Isolated word, speaker independent speech recognition

Project Goals

To make appliances smart
Use Dynamic Time Warping algorithm
13 Mel frequency Cepstral coefficients as the extracted features
Gui development and hardware interface


submitted by
Kaustubh R. Kale
Guide: Dr. John G. Harris



Description

Schematic Diagram
Endpoint detection in Java
DTW analysis in Matlab
Parallel Port operations via C++
Demo ....etc

[:=Read Full Message Here=:]

As iam from eee stream in btech,I was very much interested in doing the project on
enhancement of voltage quality in isolated power systems,due to which i need some technical support from you in providing the PPTS,PDFS regarding above mentioned topic.
thanks in advance for responding ....etc

[:=Read Full Message Here=:]

can i get a readymade plagerizm report for my topic ....etc

[:=Read Full Message Here=:]

Hello sir,
i am giving seminar on the above IEEE Paper . I am sending u the abstract of my paper.


This research paper aims to develop an isolated-word automatic speech recognition (IWASR) system based on vector quantization (VQ). This system receives, analyzes, searches and matches an input speech signal with the trained set of speech signals which are stored in the database/codebook, and returns matching results to users. IWASR is meant to assist customers calling a universitypsilas telephone operator to respond to their enquiries in a ....etc

[:=Read Full Message Here=:]

i want to know the step used for word isolated system ....etc

[:=Read Full Message Here=:]

Bridges are lifeline structures. They act, as an important page link in surface transportation network and failure of bridges during a seismic event will seriously hamper the relief and rehabilitation work. There are many cases of damage of bridges in the past earthquakes all over the world. Due to their structural simplicity, bridges are particularly vulnerable to damage and even collapse when subjected to earthquakes. The fundamental period of vibration of a majority of bridges is in the range of 0.2 to 1.2 second. In this range, the structur ....etc

[:=Read Full Message Here=:]

This article is presented by:

Yrd.Doç.Dr.Mutlu Boztepe


Transformer isolation

Objectives:
• Isolation of input and output ground connections, to meet
safety requirements
• Reduction of transformer size by incorporating high
frequency isolation transformer inside converter
• Minimization of current and voltage stresses when a
large step-up or step-down conversion ratio is needed —
use transformer turns ratio
• Obtain multiple output voltages via multiple transfo ....etc

[:=Read Full Message Here=:]

plz provide me total details to finish this project...
i need a ppt and a brief description.... ....etc

[:=Read Full Message Here=:]

Bridges are lifeline structures. They act, as an important page link in surface transportation network and failure of bridges during a seismic event will seriously hamper the relief and rehabilitation work. There are many cases of damage of bridges in the past earthquakes all over the world. Due to their structural simplicity, bridges are particularly vulnerable to damage and even collapse when subjected to earthquakes. The fundamental period of vibration of a majority of bridges is in the range of 0.2 to 1.2 second. In this range, the structur ....etc

[:=Read Full Message Here=:]

Introduction
The zero-cross family of optically isolated triac drivers is an inexpensive, simple and effective solution for interface applications between low current dc control circuits such as logic gates and microprocessors and ac power loads (120, 240 or 380 volt, single or 3-phase). These devices provide sufficient gate trigger current for high current, high voltage thyristors, while providing a guaranteed 7.5 kV dielectric withstand voltage between the line and the control circultry. An integrated, ze ....etc

[:=Read Full Message Here=:]