A Flexible GPS based system for synchronized phasor measurement in distribution networks
Submitted By:
Sethunath.S
S7 T2


INDEX

1. Abstract 3
2. Introduction 4
3. Synchrophasors 5
4. Hardware components 7
5. R ....etc

[:=Read Full Message Here=:]

how to make phasor measurement using microcontroller ....etc

[:=Read Full Message Here=:]

ABSTRACT

Optical current sensors are achieving increased acceptance and use in high voltage substations due to their superior accuracy, bandwidth, dynamic range and inherent isolation. Once deemed specialized devices intended for novel applications, optical sensors have risen to a performance level exceeding conventional magnetic devices. A specific area where optical current sensors outperform conventional iron core transformers is the measurement of very high currents that occur during a fault on the power system. Conventiona ....etc

[:=Read Full Message Here=:]

i need the basic ckt daigram of the prjct so that it can b easily implemented practically......also the theoritical knowledge of the project... ....etc

[:=Read Full Message Here=:]

A Flexible GPS based system for synchronised phasor measurement in electric distribution networks
Sreejith Mohan
S7 applied electronics
College Of Engineering, Trivandrum
2007-11 batch

CONTENTS
Need for this system
Synchrophasors
Hardware
General block diagram
Synchronized phasor evaluation
Advantages & Applications
Challenges & future works
Conclusion
Reference

Need for this system
This system can be used to develop automatic systems that are aimed at optimizing energy production and ....etc

[:=Read Full Message Here=:]

1. Abstract
The second harmonic inrush restraint function of transformerdifferential relays maintains security of the differential protectionduring transformer inrush events. The typical setpoint for thesecond harmonic restraint is the relay manufacturer’s defaultor recommended setting of 20% of fundamental current, withsome adjustment based on operating experience. However,some operating situations may result in levels of secondharmonic current lower than 20% during inrush, and levels maybe as low as 5%. This lower level of second h ....etc

[:=Read Full Message Here=:]

hello,i m ASAD ali from i m electrical engineering final year student and i m intrusted in transformer so i want to go for some good project about trasnformer
so please send me information about measurement of inrush current in transformer and how can i use it for the protection of distribution transformer by designing some relay or some thing else please give me good idea and tell me how i should start my project i hope i ll get good and very usefull guide line from you sir.

....etc

[:=Read Full Message Here=:]

plz send me pdf file for above subject ....etc

[:=Read Full Message Here=:]

Phasor measurement of wind power plant operation in Eastern Denmark



INTRODUCTION
Energinet.dk is the independent system operator (ISO) in Denmark. Until 2005 Elkraft System was the
ISO in Eastern Denmark, and this project was run as an Elkraft System project in corporation with
Centre for Electric Technology at Technical University of Denmark.
The transmission grid in Eastern Denmark encompasses overhead lines and cables at the two highest
voltage level ....etc

[:=Read Full Message Here=:]

Abstract
Large-scale distributed measurement systems are the object of several applications and research.In this article, attempts are made for developing measurement techniques that are suited to the continuous monitoring of the electrical quantities in distribution networks by using Global Positioning System (GPS) receivers. The quantities are measured in terms of synchronized phasors. general-purpose acquisition hardware and processing software is used here and as a result, the system can be easily easily reconfigured and reprogra ....etc

[:=Read Full Message Here=:]