Design of Protection system based on post fault conditions obtained using symmetrical components method.

Modern power systems operate close to their security limits and require highspeed
fault clearing to preserve transient stability, reduce fault damage, minimize
outage duration, and improve power quality. To provide high speed tripping for faults
occurring at any point on a transmission line, there must be some form of accurate
protective relays which operate on the basis of post ....etc

[:=Read Full Message Here=:]

Extraction of Red Cabbage Anthocyanins: Optimization of
the Operation Conditions of the Column Process

Marcelo Fonseca Xavier, Toni Jefferson Lopes, Mara Gabriela Novy Quadri* and
Marintho Bastos Quadri
Departamento de Engenharia Química e de Engenharia de Alimentos; Universidade Federal de Santa Catarina;
Campus Universitário Trindade; C. P.: 476; 88040-900; [email protected]; Florianópolis - SC - Brasil


ABSTRACT
The aim of this work was to extract anthocyanins from the red cabbage. Batch stu ....etc

[:=Read Full Message Here=:]

Procedure:-
1. Rewrite the given difference equation to have only the output terms on the LHS and input terms to be on RHS
2. Create a Matrix of Y coefficients, a
3. Create a Matrix of X coefficients, b
4. Generate the input sequence x(n)
5. Find the output of the system for the input sequence x(n)
6. Plot the input and the output

MATLAB program for difference equation without initial condition
clear
close all
clc

% THE INPUT SEQUENCE IS X(N) = U(N)
% THE DIFFERENCE EQUATION IS Y(N) – 0.9Y(N-1)= X(N)
% N ....etc

[:=Read Full Message Here=:]

Terms and Conditions

Welcome to seminarprojects.org!
we (seminarprojects.org staff) only providing a platform for discussing seminar and project ideas for helping students by discussing/clarifying their doubt..... ,seminarprojects.org service is operated by Omega Webs Chelari (we, us, or Omega Webs Chelari). By using the seminarprojects.org website (the Website) you agree to be bound by these Terms of Service (this Agreement). In addition, if you are an individual who wishes to become a seminarprojects.org Member (a Member), ....etc

[:=Read Full Message Here=:]

VOLTAGE STABILITY ANALYSIS UNDER NORMAL AND CONTINGENCY CONDITIONS
MINI PROJECT REPORT
Presented by
AJISHA.S

DEPARTMENT OF ELECTRICAL ENGINEERING

COLLEGE OF ENGINEERING THIRUVANANTHAPURAM-16




ABSTRACT

The load on a power system network is increasing day by day without much enhancements in transmission and or generation capability. This causes the system to operate under stressed condition, even a small disturbance can l ....etc

[:=Read Full Message Here=:]

i want the material related to single point cutting tool analysis using ansys boundary conditions ?
....etc

[:=Read Full Message Here=:]

A NEW PORTABLE EQUIPMENT FOR DETECTION OF PSYCHOPHYSICAL CONDITIONS

Abstract

This paper deals with the Disease Detector (DDX) that is a virtual reality control system for detection of
Parkinson disease.
The control system consists of a small board with an internal fuzzy micro controller capable of acquiring,
through the joystick, the well known three basic parameters (reaction, speed and force) in order to detect the
state of health and perform them by fuzzy rules. The resulting output can be visualized through a display ....etc

[:=Read Full Message Here=:]

I WANT THE ABSTRACT FOR DETECTING CONDITIONS OF REMOTE AREAS USING ZIGBEE ....etc

[:=Read Full Message Here=:]

TECHNICAL SUPPLY CONDITIONS FOR THREADED STEEL FASTENERS


NATIONAL FOREWORD
This Indian Standard ( Part 1 ) ( Third Revision ) which is identical with ISO 8992:1986 ‘Fasteners —
General requirements for bolts, screws, studs and nuts’ issued by the International Organization for
Standardization ( ISO ) was adopted by the Bureau of Indian Standards on the recommendation of the
Bolts, Nuts and Fasteners Accessories Sectional Committee and approval of the Basic ....etc

[:=Read Full Message Here=:]

clear
close all
clc
% SOLVE THE GIVEN DIFFERENCE EQUATION Y(N) - 1.5Y(N-1) + 0.5Y(N-2) = X(N), N >= 0
% X(N) = (1/4)^n * U(N) SUBJECT TO Y(-1) = 4 AND Y(-2) = 10
% CALCULATE AND PLOT THE OUTPUT OF THE SYSTEM
% FIND THE TRANSFER FUNCTION OF THE GIVEN DIFFERENCE EQUATION H(Z) = Y(Z)/X(Z)
% NUMERATOR POLYNOMIAL IS a AND DENOMINATOR POLYNOMIAL IS b
% FOR THE ABOVE EXAMPLE b = AND a =

b = ;
a = ;
% FIND THE INITIAL CONDITIONS FOR THE INPUT X SUCH THAT THE GIVEN INITIAL CONDITIONS
% FOR Y ARE OBTAIN ....etc

[:=Read Full Message Here=:]