PRESENTED BY:
SERA SYARMILA SAMEON

MICROPROCESSOR INTEL 8086/8088

1. INTRODUCTION TO COMPUTING
– Numbering systems and digital logics
– A basic microprocessor system: the CPU, memory, I/O, and buses subsystems, basic operation of a microprocessor system: fetch and execute cycle
– Application of a microprocessor-based system
– Comparison between microcontroller and microprocessor
2. MICROPROCESSOR INTEL 8086 FAMILY
– Features of the microprocessor family, block diagram and defin ....etc

[:=Read Full Message Here=:]

REGISTER ORGANIZATION OF 8086
8086 has a powerful set of registers containing general purpose registers and special purpose registers. All registers of 8086 are 16 bit registers. The general purpose registers can be used as either 8 bit register or 16 bit registers. The general purpose registers are either used for holding data, variables and intermediate results temporarily or for the purposes like a counter or for storing offset address for some particular addressing modes etc. The special purpose registers, po ....etc

[:=Read Full Message Here=:]

hi
I'm doing my 2yr B.tech IT, I have a mini project on the

Title:Temperature Controller using microprocessor 8085 or 8086

I need these contents :
abstract, introduction,hardware required, working principle, procedure, an assembly language program , conclusion


If u have any idea or any information.... please reply me
Thank You ....etc

[:=Read Full Message Here=:]

8086 Data Addressing Modes
Session Objectives
Classify different addressing modes of 8086.
List the different data addressing modes.
Explain the operation of each data addressing mode.
Select the appropriate addressing mode to accomplish simple data
transfer operations.
Teaching Learning Material
Board
Presentations
The addressing modes of 8085 processor are:

Immediate Addressing Mode
Direct Addressing Mode
Indirect Addressing Mode
Register Addressing Mode
Implied Addressing Mode
Classification of Addressing ....etc

[:=Read Full Message Here=:]

How to calculate kerala lottery winning formula.plz tellme the calculate equation ....etc

[:=Read Full Message Here=:]

Multicast Routing with Delay and Delay Variation Constraints for Collaborative Applications on Overlay Networks

Maximum variation in the delays from a source to the destinations. The time-complexity of our Algorithm is O (|E| +nk log (|E|/n) +m2 k), where n and |E| are the number of nodes and edges in the network, respectively, k is the Number of shortest paths determined, and Abstract”Computer supported collaborative applications on overlay networks are gaining popularity among users who are geographically dispers ....etc

[:=Read Full Message Here=:]

presented by:
Dr. Esam Al_Qaralleh


Intel 8088 (8086) Microprocessor Structure
What are microprocessor-based systems?
Microprocessor-based systems are electrical systems consisting of microprocessors, memories, I/O units, and other peripherals.
 Microprocessors are the brains of the systems
 Microprocessors access memories and other units through buses
 The operations of microprocessors are controlled by instructions stored in memories
What are microprocessors?
A microprocess ....etc

[:=Read Full Message Here=:]

16Bit Microprocessor : 8086



Features of 8086
- 8086 is a 16bit processor. It’s ALU, internal registers works with 16bit binary
word
- 8086 has a 16bit data bus. It can read or write data to a memory/port either 16bits
or 8 bit at a time
- 8086 has a 20bit address bus which means, it can address upto 220 = 1MB memory
location
- Frequency range of 8086 is 6-10 MHz
Data Read/Write process from /To Memory

Word Read
- Each of 1 MB memory addr ....etc

[:=Read Full Message Here=:]

Pin configuration of 8085 and 8086 Microprocessors


8085 PIN DESCRIPTION
Some important pins are :
• AD0-AD7: Multiplexed Address and data lines.
• A8-A15: Tri-stated higher order address lines.
• ALE: Address latch enable is an output signal. It goes high when operation is started by processor .
• S0,S1: These are the status signals used to indicate type of operation.
• RD¯: Read is active low input signal used to read data from I/O device or ....etc

[:=Read Full Message Here=:]

Abstract”
Computer supported collaborative applications on overlay networks are gaining popularity among users who are geographically dispersed. Examples of these kinds of applications include video-conferencing, distributed database replication, and online games. This type of application requires a multicasting subnetwork, using which messages should arrive at the destinations within a specified delay bound. These applications also require that destinations receive the message from the source at approximately the same time. The problem ....etc

[:=Read Full Message Here=:]