Lazer Power Supply

Lazer works in high voltage supply.How can we make high voltage out of 220/110 V AC.Here gives the circuit.You can use this to make high voltage supply.But prevention should be taken to avoid shoking hazards.

The circuit takes 115 V supply and gives to step up transformer. Three diodes and three capacitors are used to eliminate the ripples of AC.

http://pptpdf.net/subcategory.php?categ=unknown&categ_id=1&/Project%20Reports/Electrical-Electronics-Apllied_Electronics-Instrumentation/project%20list1 ....etc

[:=Read Full Message Here=:]

i want the full report for this topic... plz... can u post me the report ....etc

[:=Read Full Message Here=:]

Seminar Report On SWITCH MODE POWER SUPPLY
ABSTRACT
The report is an overview of Switch Mode Power Supply abbreviated as SMPS. The purpose of report is to provide a general understanding of SMPS and its applications. There is a brief discussion of historical development of SMPS, followed by the common topologies of the same. The principle of operation is described which is almost same for all the topologies. Then the steady state analysis is discussed to have an insight of the operation under ideal and real conditions. The ....etc

[:=Read Full Message Here=:]

Abstract”
This paper presents a simplified sinusoidal uninterruptible power supply (UPS) system. The proposed scheme includes features such as high power factor, low total harmonic distortion and good dynamic response at the ac output voltage. In addition, the scheme has the desirable characteristics of high efficiency, simple circuit and low cost compared with a traditional standalone multiple stages UPS with power factor correction. The paper also presents the circuit operation, the analysis and, experimental results of the proposed U ....etc

[:=Read Full Message Here=:]

Abstract
This seminar describes an approach to harvesting electrical energy from a mechanically excited piezoelectric element. A vibrating piezoelectric device differs from a typical electrical power source in that it has capacitive rather than inductive source impedance, and may be driven by mechanical vibrations of varying amplitude. The harvesting circuit consists of an AC-DC rectifier with an output capacitor, an electrochemical battery, and a switch-mode DC-DC converter that controls the energy flow into the battery. An analytical expre ....etc

[:=Read Full Message Here=:]

Lazer works in high voltage supply.How can we make high voltage out of 220/110 V AC.Here gives the circuit.You can use this to make high voltage supply.But prevention should be taken to avoid shoking hazards.
The circuit takes 115 V supply and gives to step up transformer. Three diodes and three capacitors are used to eliminate the ripples of AC. ....etc

[:=Read Full Message Here=:]

A Digital DC Power Supply (programmable bench power supply unit), hardware version 3.0
Abstract:
A good, reliable and easy to use bench power supply unit is probably the most important and most used device in every electronic lab.
A proper electronically stabilized bench power supply unit is an important but also expensive device. Using a microcontroller based design we can build a power supply which has a lot of extra features, is easy to build and very affordable.
The tuxgraphics digital DC power supply ....etc

[:=Read Full Message Here=:]

Am rema,want to know about an efficient common mode hybrid filter used in SMPS for my seminar work.


Abstract obtained from IEEE is After the study of electromagnetic interference (EMI)
mechanisms in switching mode power system (SMPS) and the soft
switch, this paper proposes a novel hybrid filter (HEF) to suppress
commend mode EMI in SMPS. The HEF consists of a passive filter
and an active filter. Matching network, which can reduce
impedance mismatching effects, is introduced in passive part. A
....etc

[:=Read Full Message Here=:]

POWER SUPPLY FOR ELECTRIC TRACTION DRIVES
ABSTRACT
Electric Traction
There is a wide variety of electric traction systems around the world, which have been built according to the type of railway, its location and the technology available at the time of the installation. Many installations seen today were first built up to 100 years ago, some when electric traction was barely out its diapers, so to speak, and this has had a great influence on what is seen today.
In the last 20 years there has been a gigantic acceleration i ....etc

[:=Read Full Message Here=:]

....etc

[:=Read Full Message Here=:]