15-STEP DIGITAL POWER SUPPLY

INTRODUCTION
This circuit will obtain variable DC voltage from 1.25v to 15.19v in reasonably small step.
The steps are according to binary codes.
These codes are obtain using Up Down counter.
This circuit works on the digital principles as we are using binary codes.
OBJECTIVE
This circuit use to we can obtain the 15 step from 1.21 to 15.19v output voltage.
This circuit give variable output voltage. (+ve) Positive and (-ve) Negative
Use LED to indicate variable 15 step voltage ....etc

[:=Read Full Message Here=:]

....etc

[:=Read Full Message Here=:]

Lazer works in high voltage supply.How can we make high voltage out of 220/110 V AC.Here gives the circuit.You can use this to make high voltage supply.But prevention should be taken to avoid shoking hazards.
The circuit takes 115 V supply and gives to step up transformer. Three diodes and three capacitors are used to eliminate the ripples of AC. ....etc

[:=Read Full Message Here=:]

Variable Power Supp ly withDigital Control
The most frequently used device inelectronic workshops and laboratoriesis a universal power supply provides a variable, fluctuation-free output.Here we present a variable power supplywith digital control that is simple and easyto construct.The circuit is built around an adjustable3-terminal positive-voltage regulatorIC LM317, CMOS decade counter ICCD4017, timer IC NE555 and 3-terminalfixed negative-voltage regulator LM7912.The AC mains supply is stepped downby transformer X1 to deliver a secon ....etc

[:=Read Full Message Here=:]

A Digital DC Power Supply (programmable bench power supply unit), hardware version 3.0
Abstract:
A good, reliable and easy to use bench power supply unit is probably the most important and most used device in every electronic lab.
A proper electronically stabilized bench power supply unit is an important but also expensive device. Using a microcontroller based design we can build a power supply which has a lot of extra features, is easy to build and very affordable.
The tuxgraphics digital DC power supply ....etc

[:=Read Full Message Here=:]

....etc

[:=Read Full Message Here=:]

Abstract
This seminar describes an approach to harvesting electrical energy from a mechanically excited piezoelectric element. A vibrating piezoelectric device differs from a typical electrical power source in that it has capacitive rather than inductive source impedance, and may be driven by mechanical vibrations of varying amplitude. The harvesting circuit consists of an AC-DC rectifier with an output capacitor, an electrochemical battery, and a switch-mode DC-DC converter that controls the energy flow into the battery. An analytical expre ....etc

[:=Read Full Message Here=:]

Lazer Power Supply

Lazer works in high voltage supply.How can we make high voltage out of 220/110 V AC.Here gives the circuit.You can use this to make high voltage supply.But prevention should be taken to avoid shoking hazards.

The circuit takes 115 V supply and gives to step up transformer. Three diodes and three capacitors are used to eliminate the ripples of AC.

http://pptpdf.net/subcategory.php?categ=unknown&categ_id=1&/Project%20Reports/Electrical-Electronics-Apllied_Electronics-Instrumentation/project%20list1 ....etc

[:=Read Full Message Here=:]

Abstract”
This paper presents a simplified sinusoidal uninterruptible power supply (UPS) system. The proposed scheme includes features such as high power factor, low total harmonic distortion and good dynamic response at the ac output voltage. In addition, the scheme has the desirable characteristics of high efficiency, simple circuit and low cost compared with a traditional standalone multiple stages UPS with power factor correction. The paper also presents the circuit operation, the analysis and, experimental results of the proposed U ....etc

[:=Read Full Message Here=:]

i have ppt of 15 step digital power supply ....etc

[:=Read Full Message Here=:]