In this seminar a method for wideband harmonic compensation is presented. The main circuit configuration of the system is shown in Fig. 2. The system compensates the low order harmonics using a simple computational control delay compensation method, while the high order harmonics are filtered with a small passive high pass filter. In the system the whole filtering band of the APF is utilized and the filtering performance is recovered with an HPF when the ability of the APF to filter harmonics effectively is impaired. This way the size of the pa ....etc

[:=Read Full Message Here=:]

pls give me some ieee papers on this topic ....etc

[:=Read Full Message Here=:]

presented by:
J.Chaithanya Bharathi
A.L.Harika
P.Divya Sree


ABSTRACT
The performance of any machine can be analyzed with reference to parameters like power factor, total harmonic distortion, voltage regulation, etc. These parameters alter when a machine is subjected to different loads. Depending on the load connected to the system, the voltage and current waveforms are varied. Due to the effect of harmonics, distortion of waveforms from sinusoidal to non sinusoidal is c ....etc

[:=Read Full Message Here=:]

ABSTRACT.
The ultrasonic testing of concrete structures has posed many problems. Conventional methods such as pulse echo and pitch catch are of limited use due to its composition, aggregates will cause scattering and multiple reflections. Alternative ultrasonic methods have been recently investigated that examine the shape of the waveform as it traverses through a complex material, the idea being not to located a single defect but to determine the overall mechanical properties within a certain region. In damaged materials, particularly ones ....etc

[:=Read Full Message Here=:]

ABSTRACT

This paper focuses on a shunt active filter based on the detection of harmonic voltages at the point of installation. The objective of the active filter is to attenuate harmonic propagation resulting from series/parallel resonance between capacitors for power factor correction and line inductors in a power distribution line. The active filter acts as a low resistor to the external circuit for harmonic frequencies, and it is installed on the end bus of the power distribution line, just like a 50 O terminator installed on the end ter ....etc

[:=Read Full Message Here=:]

SIR
I AM IN GREAT NEED OF INFORMATION REGARDING COMPENSATION OF HARMONIC CURRENTS UTILIZING AHC. I WILL BE VERY THANKFUL IF U SEND ME THE REQUIRED INFORMATIION.
THANKING YOU SIR
SAVITHA K ....etc

[:=Read Full Message Here=:]

Today, the situation on low-voltage AC systems has become a serious concern.The quality of electrical power in commercial and industrial installations is undeniably decreasing. In addition to external disturbances, such as outages, sags and spikes due to switching and atmospheric phenomena, there are inherent, internal causes specific to each site and resulting from the combined use of linear and non-linear loads.Untimely tripping of protection devices, harmonic overloads, high levels of voltage and current distortion, temperature rise in condu ....etc

[:=Read Full Message Here=:]

Differences between single effect evaporator and multiple effect evaporator ....etc

[:=Read Full Message Here=:]

Today, the situation on low-voltage AC systems has become a serious concern.The quality of electrical power in commercial and industrial installations is undeniably decreasing.


In addition to external disturbances, such as outages, sags and spikes due to switching and atmospheric phenomena, there are inherent, internal causes specific to each site and resulting from the combined use of linear and non-linear loads.

Untimely tripping of protection devices, harmonic overloads, high levels of voltage and current distortion, temperature rise ....etc

[:=Read Full Message Here=:]

Today, the situation on low-voltage AC systems has become a serious concern.The quality of electrical power in commercial and industrial installations is undeniably decreasing. In addition to external disturbances, such as outages, sags and spikes due to switching and atmospheric phenomena, there are inherent, internal causes specific to each site and resulting from the combined use of linear and non-linear loads.Untimely tripping of protection devices, harmonic overloads, high levels of voltage and current distortion, temperature rise in condu ....etc

[:=Read Full Message Here=:]