please i am Richeson Solomon a student, i want to write a project report on effective distribution of popwer from a sub-station. i want you to help me with a suitable table of content that can easly help me to gather more informations. and please if possible you can send me a similar project report if someone has written a report on that topic. please this is my emial address [email protected]
....etc

[:=Read Full Message Here=:]

Control Dynamics of a Doubly Fed Induction Generator Under Sub- and Super-Synchronous Modes of Operation


M. Aktarujjaman, Student Member,
IEEE, M.E. Haque, Member, IEEE, K. M. Muttaqi, Senior
Member, IEEE, M. Negnevitsky, Member,
IEEE and G. Ledwich, Senior Member, IEEE


Abstract-
Abstract—
Depending on wind speed, a doubly fed induction generator (DFIG) based variable speed wind turbine is capable of operating in sub- or super-synchronous mode of operation using a back to back PWM co ....etc

[:=Read Full Message Here=:]

ABSTRACT
Good people all, of every sort, give ear unto my song , this was the cry
made by thousands of operator running to and fro to detect, analyze and report the fault to their
senior officials and wait for their instructions to be followed. Finally someone heard their cry and a
master system was born. The energy is generated, transmitted, distributed and finally utilized. At
every stage certain supervision, control and protection is neces sary. This paper deals with basic
SCADA system, its components, basic block ....etc

[:=Read Full Message Here=:]

an electrical sub-station

abstraction

This is the basic discipline in the field of electrical power transmission

. An electrical sub-station chiefly deals with the distribution of power to the user end from the generator side. So it becomes essential to have proper protection schemes for it

. So it is necessary for every electrical engineer to know the dynamics of the functioning of it.

....etc

[:=Read Full Message Here=:]

An improvised MOS transistor model suitable for
Geometric Program based analog circuit sizing in
sub-micron technology

A special monomial form of the device model is required by the Geometric program. This article describes the work done in identifying the sources of inaccuracy in this basic model. The strict monomial form has been relaxed. the sizing problem is solved as a series of geometric programs instead of solving it considering as single entity. a folded-cascode op-amp sizing example is used to describe the efficiency of t ....etc

[:=Read Full Message Here=:]

Introduction


The present day electrical power system is a.c. i.e. electric power is generated, transmitted and distributed in the form of Alternating current. The electric power is produce at the power station, which are located at favorable places, generally quite away from the consumers. It is delivered to the consumer through a large network of transmission and distribution. At many place in the line of power system, it may be desirable and necessary to change some characteristic ( e.g. Voltage, ac ....etc

[:=Read Full Message Here=:]

SUB CODE SUBJECT NAME NAME CONTINUE…,FILL ALGORITHMS
Name of Department

CHAROTAR INSTITUTE OF TECHNOLOGY, CHANGA


FILL ALGORITHMS

Given the edges defining a polygon, and a color for the polygon, we need to fill all the pixels inside the polygon.
Three different algorithms:
1. Scan-line fill
2. Boundary fill
3. Flood fill
Boundary Fill
Suppose that the edges of the polygon has already been colored.
Suppose that the interior of the polygon is to be colored a different color from the edge.
Suppo ....etc

[:=Read Full Message Here=:]

Benton Highsmith Calhoun, Member, IEEE, and Anantha P. Chandrakasan, Fellow, IEEE

Abstract—
Low-voltage operation for memories is attractive because of lower leakage power and active energy, but the challenges of SRAM design tend to increase at lower voltage. This paper explores the limits of low-voltage operation for traditional six–transistor (6 T) SRAM and proposes an alternative bitcell that functions to much lower voltages. Measurements confirm that a 256-kb 65-nm SRAM test chi ....etc

[:=Read Full Message Here=:]

FIBRE-REINFORCED FLY ASH SUB-BASES IN RURAL ROADS

SUB-BASE COURSES AND THEIR EVALUATION

SUB-BASE IS MADE OF BROKEN STONES,BOUND OR UNBOUND AGGREGATE

SUB-BASE COURSE PRIMARILY HAS THE SIMILAR FUNCTION AS OF THE BASE COURSE AND PROVIDED WITH INFERIOR MATERIALS THAN OF BASE COURSE

THE FUNDAMENTAL PURPOSE OF SUB “BASE IS TO PROVIDE A STRESS TRANSMITTING MEDIUM TO SPREAD THE SURFACE WHEEL LOADS IN SUCH A MANNER TO PREVENT SHEAR AND CONSOLIDATION DEFORMATIONS


FIBRE-REINFORCED FLYASH AS SUB-BASE
....etc

[:=Read Full Message Here=:]

Dear sir,
pls discuss about the Fabrication of twin spindle drill holder.
....etc

[:=Read Full Message Here=:]