I am looking for CMOS differential amplifier details....
give me details about cmos differential amplifier. ....etc

[:=Read Full Message Here=:]

plz give me the accurate answer of this question..
why 470 ohm resistors used in metro train prototype ?
I am waiting for your answer.. ....etc

[:=Read Full Message Here=:]

Digital technology continues its march from media like CDs and DVDs toward your audio speakers. Today, amplifiers based on digital principles are already having a profound effect on equipment efficiency and size. They are also beginning to set the standard for sound quality.

An old idea, the Class D amplifier has taken on new life as equipment manufacturers and consumers redefine the musical experience to be as likely to occur in a car, on a personal stereo, or on an airplane as in a living room. For most consumers today, portability and st ....etc

[:=Read Full Message Here=:]

POWER SUPPLY NOISE REDUCTION USING ACTIVE RESISTORS


Introduction

Continual scaling in integrated circuit technology has made it possible to achieve higher transistor density
in a given die area. Even with the lowering of the power supply voltage for newer process nodes, the
maximum power consumption of high-end microprocessors has been projected to continue to increase for
the foreseeable


Resistive Damping

The oscillations in the power supply ....etc

[:=Read Full Message Here=:]

Differences between single effect evaporator and multiple effect evaporator ....etc

[:=Read Full Message Here=:]

Common mode rejection ratio (CMRR) is important performance parameter of any difference amplifier. It is the ratio of the differential gain to the common-mode gain, generally expressed in dB. It signifies the ability of an opamp to reject common mode signal, the signal which appears simultaneously at both its input terminals. The CMRR is of great importance when it comes to noise rejection. For applications involving high CMRR, instrumentation amplifiers consisting of three opamps are generally used. It has a major disadvantage that the value o ....etc

[:=Read Full Message Here=:]

Hello i need power supply noise reduction using active resistors ppt & document in IEEE format immediately an u please forward that to my email
[email protected] ....etc

[:=Read Full Message Here=:]

Common Emitter BJT Amplifier Design Current Mirror Design


Some Random Observations
● Conditions for stabilized voltage source biasing
● Emitter resistance, RE, is needed.
● Base voltage source will have finite resistance, RB.
● needs to be much larger than RB.
● Small RB - relative to RS - will attenuate input signal.
● Larger RE permits larger RB, but results in lower gain.
● Gain = -RC/RE for RE >> re.
● Split RE with bypassing increa ....etc

[:=Read Full Message Here=:]

CAPACITIVELY COUPLED INSTRUMENTATION AMPLIFIER FOR POWER AND SIGNAL ISOLATION
Presented by
Archana Nair I
S7 AEI
College Of Engineering, Trivandrum
2007-11 batch





Overview

Biopotential and biopotential amplifier.

Bidirectional data transfer and power exchange.

Development of the instrumentation.

Evaluation of system’s suitability for biopotential measurements.
Need for isolation

Any potential or current at amplifier’s input terminals ....etc

[:=Read Full Message Here=:]

Digital Audio's Final Frontier-Class D Amplifier

Digital technology continues its march from media like CDs and DVDs toward your audio speakers. Today, amplifiers based on digital principles are already having a profound effect on equipment efficiency and size. They are also beginning to set the standard for sound quality.

An old idea, the Class D amplifier has taken on new life as equipment manufacturers and consumers redefine the musical experience to be as likely to occur in a car, on a perso ....etc

[:=Read Full Message Here=:]