PRESENTED BY:
AVINANDAN SANDILYA


ALUMINIUM AND ITS ALLOYS
INTRODUCTION
 It is the third most abundant element of 8% on earth crust and normally found in oxide forms. It is a non-ferrous metal.
 It does not occur free in nature.
 Therefore it remained unknown until the nineteenth century.
ORES OF ALUMINIUM
ALLOYS OF ALUMINIUM
Designations of wrought aluminium alloys
Non-heat-treatable alloys
1xxx series (Super-purity and commercial-purity aluminium)
3xxx series (Al-Mn a ....etc

[:=Read Full Message Here=:]

Silicon Carbide Photodiode Flame Temperature Sensors in an Active Combustion Pattern Factor Control System


Introduction
The combustion pattern factor in a gas turbine is a measurement
of the difference between the peak and average temperature at the
turbine inlet.
where Tpeak is the measured peak temperature at the combustor
exit and Tavg is the average of the measured temperatures.
The objective of active pattern factor control APFC is ....etc

[:=Read Full Message Here=:]

An Integrated Silicon Carbide (SiC) Based Single Phase Rectifier with Power Factor Correction



I. INTRODUCTION
Power supplies are one of the most crucial building
blocks of a modern society, converting high-voltage AC
into low-voltage DC for use in electronic circuitry in office
equipment, telecommunication, and consumer electronics.
Over 2.5 billion AC/DC power supplies are currently in use
in the United States alone, about 6 to 10 billion are in use
....etc

[:=Read Full Message Here=:]

i am swati i would like to get details on boron chemistry applications to cancer treatment ..My friend arati said boron chemistry applications to cancer treatment will be available here and now i am living at ......... and i last studied in the college/school ......... and now am doing ....i need help on ......etc ....etc

[:=Read Full Message Here=:]

Please give all ppt about boron chemistry in applicatio of cancer treatment ....etc

[:=Read Full Message Here=:]

Please give the article about boron chemistry and application of cancer treatment ....etc

[:=Read Full Message Here=:]

Particle reinforced MMC?s are now being produced commercially and in this paper the various processing techniques used for the production of aluminium composites and factors affecting their quality are overviewed. The various techniques like powder metallurgy, spray deposition, molten metal infiltration, molten metal mixing, liquid metallurgy, compo-casting technique etc. The factors affecting the uniform dispersion of the composites and the various properties of the metal matrix composites are also discussed. Aluminium alloy matrix particulate ....etc

[:=Read Full Message Here=:]

I would like to know about boron chemistry and application to cancer treatment ....etc

[:=Read Full Message Here=:]

Boron chemistry and applications to cancer treatment. ....etc

[:=Read Full Message Here=:]

Abstract

Rapid urbanization has resulted in drastic increase in housing demand today. The traditional or conventional method of construction for mass housing is comparatively, a slow process and has limited quality control, particularly when a large size project is involved. It is therefore obligatory to work out a method or a scheme where the speed and quality of construction are controlled automatically by a systematic approach. Many methods have emerged and have been tried out and are still being adopted ....etc

[:=Read Full Message Here=:]