Scalable Wireless Ad-Hoc Network Simulation using XTC

Project Pre requisitions:-
The XTC ad-hoc network topology control algorithm shows three main advantages over previously proposed algorithms. First, it is extremely simple. Second, it does not assume the network graph to be a Unit Disk Graph; XTC proves correct also on general weighted network graphs. Third, the algorithm does not require availability of node position information. Instead, XTC operates with a general notion of order over the neighborsâ„¢ page l ....etc

[:=Read Full Message Here=:]

REVIEW OF CFL AND ITS HARMONIC IMPACT ON ELECTRICAL DISTRIBUTION SYSTEM


Guide: Mr. Rijo Rajan, prepared by: Merin Lukose
Lecturer, S7 EEE
EEE department.




INTRODUCTION


Energy advantages of CFL has made it a common lighting device recently.

CFL comprises of electronic components which ....etc

[:=Read Full Message Here=:]

i need fulldetails about this paper ....etc

[:=Read Full Message Here=:]

hai
i'm looking for circuit diagram of BPL rechargeable emergency CFL light to repair a PCB of BPL part no.04474 on my own. please help me on this.
thanks ....etc

[:=Read Full Message Here=:]

AUTO FLIGHT PILOT SIMULATION APPLIED IN REAL TIME AND REMOTE MONITORING USING HIGH SPEED RF DATA LINK FOR UAV / FLIGHT.

ABSTRACT: The use of Unmanned Arial Vehicle (UAV) become vital in the modern world as the activities of UAV is unequal. The main navigation system used in the UAV is a remote controlled pilot system. The real pilot, who is sitting remotely with all control equipment and monitoring system become a real cockpit and it is necessary to control all parameters in real time at higher accuracy.
The project mentioned here is the re ....etc

[:=Read Full Message Here=:]

CFL modelling and simulation in PSIM software ....etc

[:=Read Full Message Here=:]

A Project Report on
Simulation Testbed for Evaluation of
Critical Software in Launch Sequence
Submitted in Partial fulfillment of the requirements for the award of
the degree of
Master of Technology
In
Software Engineering
Submitted by
Sreebal I S
Under the Esteemed Guidance of
Mr. Santhosh Kumar G
Lecturer
Dept. of Computer Science, CUSAT
DEPARTMENT OF COMPUTER SCIENCE,
COCHIN UNIVERSITY OF SCIENCE AND TECHNOLOGY,
KOCHI-682022, KERALA
JUNE 2008Page 2
Page 3

DEPARTMENT OF COMPUTER SCIENCE,
COCHIN UNIVERSITY OF SCIENCE AND ....etc

[:=Read Full Message Here=:]

Abstract
Wireless sensor networks provide the smallest and cheapest form of wireless communicating and computing devices due to the advances in Processor, memory and radio technology. These wireless sensor networks pose significantly different design, implementation, and deployment challenges. In this project, I present a simulation of the wireless sensor network for paging applications. These pagers can provide small data transfer and can be used to transfer small pieces of information between themselves. A pager is a wireless sensor mote wh ....etc

[:=Read Full Message Here=:]

Abstract
A new printed antenna system mounted in an aperture in the roof of a car is evaluated for broadcast signal reception from 88-108 MHz. Results from simulations on the vehicle are compared with measurements. The overall performance of the antenna is also compared to common types of vehicle antennas, the roof monopole and a glass based antenna. Overall the average gain of the antennas was better than -3 dBi for vertical polarization and -10 dBi for horizontal while the input return loss was generally better than -2 dB before matching sec ....etc

[:=Read Full Message Here=:]

CPU Scheduler A Simulation ....etc

[:=Read Full Message Here=:]