Finite-Element Simulation of Electrical Discharge Machining (EDM) Process


I. INTRODUCTION
Electric discharge machining (EDM), sometimes
colloquially also referred to as spark machining, spark
eroding, burning, die sinking or wire erosion, is a
manufacturing process whereby a desired shape is obtained
using electrical discharges (sparks). Material is removed
from the workpiece by a series of rapidly recurring current
discharges between two electrodes, se ....etc

[:=Read Full Message Here=:]

These are IEEE network simulation projects developed in OMNeT++ 3.2.

1. Minimum Distance Packet Forwarding

This IEEE Journal Technology Simulation Project is the simulation of Minimum Distance Packet Forwarding for search application in Network (P2P) using OMNeT++ 3.2 tool. This technique is based on technique published on IEEE Transaction paper.

2. Endpoint Admission Control

This IEEE Journal Technology Simulation Project is the simulation of Probing Mechanism for Endpoint Admission Control in Network (P2P) using OM ....etc

[:=Read Full Message Here=:]

ABSTRACT



Because of high requirements in power, efficiency, installation space and weight, the design of electrical machines for hybrid electrical vehicles is a particular challenge. This seminar describes a comparative study allowing the selection of the most appropriate electric-propulsion system for a parallel hybrid electric vehicle (HEV). This seminar is based on an exhaustive review of the state of the art and on an effective comparison of the performances of the four main electric propulsion systems, namely the d ....etc

[:=Read Full Message Here=:]

give me the project report RELATED TO MODELING AND SIMULATION OF WIND ENERGY POWER SYSTEM ....etc

[:=Read Full Message Here=:]

1.Zero voltage regulation in a transformer occurs at :
(A)zero p.f. lead 
(B)unity p.f.
(C )leading p.f.
(D)lagging p.f.

2.A parallel plate capacitor has 15 p.F capacitance. If the linear dimensions of the plate are doubled and the distance between the plates are also doubled, then new value of capacitance would be :
(A)15uF
(B)30 uF
(C )60 uF
(D)7.5 u.F

3.Resistance of a 230 V 100 W bulb is R1 and that of a 230 V 75 W is R2. Then,
(A)R1= R2
(B)R1 > R2
(C )R1 < R2
(D)R1 - 2R2

4.The current in a series ....etc

[:=Read Full Message Here=:]

Prepared by:
Zhen Yu and Arthur Dexter

Abstract

Simulation based control schemes for a low-energy building system are introduced and compared in this paper. The simulation of a low-energy system is firstly constructed and a fast two-stage optimisation method is proposed to find the optimal control policy in short time. A Model Predictive Control (MPC) scheme and a Hierarchical Fuzzy Rule based Control (HFRC) scheme that is tuned online by a reinforcement learning (RL) agent are introduced. The MPC scheme runs the simulatio ....etc

[:=Read Full Message Here=:]

harmonic distortion control in traction system ....etc

[:=Read Full Message Here=:]

need detailed data and full seminar report ....etc

[:=Read Full Message Here=:]

SLOT VIEW SIMULATION OF WIND ELECTRICAL SYSTEMS



ABSTRACT
As a result of increasing environmental concern, more and more electricity is generated from renewable sources. One way of generating electricity from renewable sources is to use wind turbines. A tendency to erect more and more wind turbines can be observed. As a result of this, in the near future wind turbines may start to influence the behaviour of electrical power systems. Therefore, adequate model ....etc

[:=Read Full Message Here=:]

i need fulldetails about this paper ....etc

[:=Read Full Message Here=:]