REENTRY TERMINAL GUIDANCE THROUGH SLIDING MODE CONTROL
SEMINAR REPORT
submitted in partial fulfillment of
the requirements for the award of M.Tech Degree in
Electrical and Electronics Engineering (Guidance and Navigation Control)
of the University of Kerala
Submitted by
DEVIKA K.B.
First Semester
M.Tech, Guidance a ....etc

[:=Read Full Message Here=:]

ABSTRACT
Re-entry capsules promises to intensify international competition in launch services, microgravity research and space technology development. These systems will also confer an important strategic advantage in the conduct of materials and in life science research.
The objective of this paper is to provide a modest degree of understanding of the complex inter-relation which exist between performance requirements mission constraints , vehicle design and trajectory selection of typical re-entry mission. A brief prese ....etc

[:=Read Full Message Here=:]

I am a post graduate diploma student studying Environmental Management.Please I need this project topic for my own project ....etc

[:=Read Full Message Here=:]

ABSTRACT
Re-entry capsules promises to intensify international competition in launch services, microgravity research and space technology development. These systems will also confer an important strategic advantage in the conduct of materials and in life science research.
The objective of this paper is to provide a modest degree of understanding of the complex inter-relation which exist between performance requirements mission constraints , vehicle design and trajectory selection of typical re-entry mission. A brief prese ....etc

[:=Read Full Message Here=:]

REENTRY TERMINAL GUIDANCE THROUGH SLIDING MODE CONTROL
SEMINAR REPORT
submitted in partial fulfillment of
the requirements for the award of M.Tech Degree in
Electrical and Electronics Engineering (Guidance and Navigation Control)
of the University of Kerala
Submitted by
DEVIKA K.B.
First Semester
M.Tech, Guidance a ....etc

[:=Read Full Message Here=:]

A moving train contains energy, known as kinetic energy, which needs to be removed from the train in order to cause it to stop. The simplest way of doing this is to convert the energy into heat.

The conversion is usually done by applying a contact material to the rotating wheels or to discs attached to the axles. The material creates friction and converts the kinetic energy into heat. The wheels slow down and eventually the train stops. The material used for braking is normally in the form of a block or pad

The vast majority of the ....etc

[:=Read Full Message Here=:]

INTEGRATED GUIDED MISSILE DEFENCE PROGRAMME (IGMDP)
ABSTRACT
IGMDP “ INTEGRATED GUIDED MISSILE DEFENSE PROGRAMME

The Integrated Guided Missile Defense System (IGMDP) is the most advanced technology in the field of ballistic war faring. Perfectly pin pointing enemy missiles and striking them airborne forms the essence of this technology. Precision and accuracy are the most inevitable factors that have to be ensured here. This system makes use of several stages comprising of different equipments and the integra ....etc

[:=Read Full Message Here=:]

sir!!! i would like to know about the materials used in space re entry vehicles for my tchnical seminar... and i want a ppt about the topic.... ....etc

[:=Read Full Message Here=:]

ABSTRACT



The term plotted ignition is applied to the case in the which an engine is equipped with a technology where the spark time is advanced with the speeds. In an engine the spark advance angle required increases with an increase in the speed. This technology actually advances the spark timing and gives a correct time so that the mixture gets enough time to burn to a near net completion.

password:seminarprojects

CHAPTER -I
INTRODUCTION



The purpose of the ignition system is t ....etc

[:=Read Full Message Here=:]

Atmospheric Radiation




Introduction

• The major source of earth is the sun.
• The sun transfer energy through the earth by radiated
electromagnetic wave.
• In vacuum, electromagnetic waves travel at speed of light (300,000
km/s).
• The continuous electromagnetic spectrum distinguishes different
types of waves based on wavelength and frequency.


Heat Transport in Atmosphere

• Transport of heat is accomplis ....etc

[:=Read Full Message Here=:]

ABSTRACT
This paper brings out the significance of fluidized combustion technology. The atmospheric as well as pressurized fluidized bed
combustion is discussed. Development of fluidized bed boilers and
their present status in the fluidized combustion technology is also
presented. Fluidized combustion technology is the superior one when
compared with other combustion technologies present in India today.
With out making any more developments in the advanced gas turbine
technology, it is possible to generate electricity in an econo ....etc

[:=Read Full Message Here=:]

Image Processing and Analysis


Introduction
Image Processing and Analysis can be defined as the act of examining images for the purpose of identifying objects and judging their significance Image analyst study the remotely sensed data and attempt through logical process in detecting, identifying, classifying, measuring and evaluating the significance of physical and cultural objects, their patterns and spatial relationship.

Digital Data
In a most generalized way, a digital image is an array of numbers depicting spati ....etc

[:=Read Full Message Here=:]

SCRAMJET
SEMINAR REPORT
BY
HARISHANKER
DEPARTMENT OF MECHANICAL ENGINEERING
LOURDES MATHA COLLEGE OF SCIENCE&TECHNOLOGY
KUTTICHAL, THIRUVANANTHAPURAM
NOVEMBER 2010




ABSTRACT

A scramjet (supersonic combustion ramjet) is reminiscent of a ramjet. The basic components of scramjet are inlet, diffuser, fuel injector, flame holder, igniter, and combustion chamber and exhaust nozzle. The basic principle of scramjet is same as that of any type of engine, intake, compression, combustion ....etc

[:=Read Full Message Here=:]

ABSTRACT



Light Detection and Ranging (LIDAR) have recently become the technologies of choice in mass production of Digital Elevation Models (DEMs), Digital Terrain Models (DTMs), and Triangulated Irregular Networks (TINs), referred to generically hereafter as DEMs. This paper presents lessons learned from LIDAR projects to date in various states. It addresses opportunities presented by LIDAR for generating DEMs as articulated by various user groups in the National Height Modernization Study. Finally, it summarizes actions required b ....etc

[:=Read Full Message Here=:]