An Integrated Silicon Carbide (SiC) Based Single Phase Rectifier with Power Factor Correction



I. INTRODUCTION
Power supplies are one of the most crucial building
blocks of a modern society, converting high-voltage AC
into low-voltage DC for use in electronic circuitry in office
equipment, telecommunication, and consumer electronics.
Over 2.5 billion AC/DC power supplies are currently in use
in the United States alone, about 6 to 10 billion are in use
....etc

[:=Read Full Message Here=:]

K.J.V. ALLOY CONDUCTORS PVT. LTD.



COMPANY PROFILE :
We started our operations with manufacturing AAC (All Aluminium Conductor), ACSR (Aluminium Conductor Steel Reinforced), Bare Aluminum Wire & Strips, Bare Aluminum Alloy Wire, in theyear 1989. Subsequently we included AAAC (All Aluminium Alloy Conductor) & Paper Covered (Insulated) Wire & Strips to our product mix for distribution & transmission power lines .

SUPPLIES TO :
....etc

[:=Read Full Message Here=:]

Guideline for Aluminum Alloy Conductors for Distribution Feeder Applications with Recommendations for Connections



A Distribution Feeder Installation
1 Distribution feeder conductors in sizes #6 AWG to 1000 kcmil may be copper
or aluminum conductor material (ACM).
i. Aluminum alloy conductors shall be compact stranded conductors of
NUAL® (AA-8030) as manufactured by Alcan Cable or of a recognized
8000 Series aluminum alloy conductor material by the Alum ....etc

[:=Read Full Message Here=:]

ABSTRACT:
Conventional closed die forging, is widely used for manufacture of superalloy parts. Despite recent technological advancements in the area of forging design, empirical and trial-and-error methods are still widely used in forging super alloy materials. This paper investigates the effect of flash thickness and various geometrical forging design parameters including internal and external drafts and internal and external corner radii, on the die cavity filling, forging load and raw material cost when forging Nimonic80-A a supera ....etc

[:=Read Full Message Here=:]

Abstract
Conditions were determined for consistent coupling of a CO2 laser beam to weld 5182 aluminum
alloy sheet. Full penetration butt and bead-on-plate welds on 0.8 and 1.8 mm sheets were
performed. Process conditions examined included beam mode, spot size and irradiance,
shielding gas flow, and edge quality and fitup. The observed weld quality variations with the
different process parameters were consistent with physical phenomena and a threshold irradiance
model. Optimal conditions were determined for obtaining consistent wel ....etc

[:=Read Full Message Here=:]

i need full notes of mechanics of composite materials
....etc

[:=Read Full Message Here=:]

please send ppt for biodegradable composite material....
thanking you. ....etc

[:=Read Full Message Here=:]

how to make contact aluminum and carbon fiber/epoxy in ANSYS software............ ....etc

[:=Read Full Message Here=:]

Silicon Carbide Photodiode Flame Temperature Sensors in an Active Combustion Pattern Factor Control System


Introduction
The combustion pattern factor in a gas turbine is a measurement
of the difference between the peak and average temperature at the
turbine inlet.
where Tpeak is the measured peak temperature at the combustor
exit and Tavg is the average of the measured temperatures.
The objective of active pattern factor control APFC is ....etc

[:=Read Full Message Here=:]

i am final year mech can i
do this project ....etc

[:=Read Full Message Here=:]