Vector Control of AC Induction Motors



Introduction

Scalar control of ac drives produces good steady state performance but poor dynamic response. This manifests itself in the deviation of air gap flux linkages from their set values. This variation occurs in both magnitude and phase.

Vector control (or field oriented control) offers more precise control of ac motors compared to scalar control. They are therefore used in high performance drives where ....etc

[:=Read Full Message Here=:]

Presented by-
MOINUDDIN M SHIRBADGI


Abstract - Some form of simple control is needed for small induction motors. This paper proposes a simple speed control method for small induction motors using a simple calculation without the need for a speed sensor. In this method, the load torque is estimated from the detected power factor of the induction motor and the speed of the induction motor is compensated for by a frequency-boost technique. The boost frequency is selected from a data table measured before hand. Sa ....etc

[:=Read Full Message Here=:]

Implementing Embedded Speed Control for AC Induction Motors



Physics of Induction Motors

•Current passing through a conductor creates magnetic field–Direction of magnetic field is determined by the right hand rule•Changing magnetic field produces current in a conductor–Direction of current is determined by right hand rule•Electromagnetic Induction–Changing current induces changing magnetic field around it. –A conductor placed in this field has induced current and induced magnetic field•Inte ....etc

[:=Read Full Message Here=:]

Abstract:
This paper deals with the direct torque control of capacitor multilevel VSI actuators. The active control strategy high voltage I high power induction motors fed by floating egy for well-balancing the capacitor voltages is presented highlighting an optimal pattern. The efficiency of this approach is compared to the well-known passive method and it is illustrated by simulation. In the next section, a controlled cycle based algorithm is proposed as an attractive solution for a high performance torque control ....etc

[:=Read Full Message Here=:]

CAN-based Synchronized Motion Control for Induction Motors

Abstract:

A control area network (CAN) based multi-motor synchronized motion control system with an advanced synchronized control strategy is proposed. The strategy is to incorporate the adjacent cross-coupling control strategy into the sliding mode control architecture. As illustrated by the four-induction-motor-based experimental results, the multi-motor synchronized motion control system, via the CAN bus, has been successfully implemented. With the emplo ....etc

[:=Read Full Message Here=:]

Abstract:
The field oriented control emerged as an important approach for the control of AC machines, and continues to be explored and developed in the literature. The estimation of the rotor flux from the measurable variables was the only method used to implement the vector control of the induction machine. To replace the estimator based on the mathematical model of the system, which can lead to unintended errors due to uncertainties on the model and on the measures we use an appropriate observer.

Presented By:
Ch ....etc

[:=Read Full Message Here=:]

PLC-Based Monitoring Control System for Three-Phase Induction Motors
The article presents a monitoring and control system design and implementation for the three-phase induction motor based on programmable logic controller (PLC) technology. the operational parameters of the motor is correlated with the the speed requested by the user by the PLC. This is done in both the during normal operation and under trip conditions. Tests prove that a higher accuracy in speed regulation is provided by the induction motor system driven by inverter a ....etc

[:=Read Full Message Here=:]

This article is presented by:
O. Barambones∗, A.J. Garrido∗, F.J. Maseda∗ and P. Alkorta†Speed Sensorless Vector Control of Induction Motors Based on
Robust Adaptive Variable Structure Control Law

ABSTRACT
A novel sensorless adaptive robust control law is proposed to improve the trajectory tracking performance of induction motors. The proposed design employs the so called vector (or field oriented) control theory for the induction motor drives and the designed ....etc

[:=Read Full Message Here=:]

send clear details about this project ....etc

[:=Read Full Message Here=:]

73. RF CONTROL OF INDUCTION MOTORS AND OTHER INDUSTRIAL LOADS
# can I know more information about that Topic?
# and where can this project apply? :idea::D ....etc

[:=Read Full Message Here=:]