1. Introduction

Voice morphing means the transition of one speech signal into another. Like image morphing, speech morphing aims to preserve the shared characteristics of the starting and final signals, while generating a smooth transition between them. Speech morphing is analogous to image morphing. In image morphing the in-between images all show one face smoothly changing its shape and texture until it turns into the target face. It is this feature that a speech morph should possess. One speech signal should smoothly change into another, ....etc

[:=Read Full Message Here=:]

Automatic meter reading (AMR) is the technology of automatically collecting data from energy metering devices (water, gas, and electric) and transferring that data to a central database for billing and/or analyzing ....etc

[:=Read Full Message Here=:]

to get project report with source code for specific electrical engineering project please browse through this page http://studentbank.in/topic-electronics-electrical-instrumentation-applied-electronics-project-ideas



1. Transformer protection panel
2. Working Model of maglev
3. Maximum power point Tracking
4. Motorised wheel Chair
5. Controller of Electrical Vehicale
6. Deregulation of Energy Sector
7. Cathodic protection
8. Radial Feeder protection
9. PLC Based System
10. Numerical Relay
11. ....etc

[:=Read Full Message Here=:]

1. SMS based Device / Home Equipment Control System
2. Remote Motor Speed Control using Cell Phones
3. GPS Based traffic Monitoring system
4. GPS Based fleet Management System
5. Implementation of Mobile/ Cell phone Jamming systems Design
6. Intelligent Security System for industrial Surveillance with GSM & Auto Dialer
7. GSM Based Remote monitoring system for Electronic Energy meters
8. Wireless distributed energy billing system using GSM
9. HNet “ a Home Network System with Mobile Communication
10. Distance Measuring using U ....etc

[:=Read Full Message Here=:]

in this project need to designe a circuit which contains a micro controller which Sends the serial data through its serial port every time after resetting. Then it sends the data by RF using DTMF tones.
Now after transmitting the data micro controller wait for some time and then again transmit it.

Information transmission by IR:-
These informationâ„¢s are pre feeded into the microconrollers ROM and by using infrared LED in the following way :-
As we know that sensors only detects 38 KHz IR signal so we modulate the 38KHz signal ....etc

[:=Read Full Message Here=:]

Hi Dear,

I would like to have circuit diagram of 38khz remote control using ic NE555.

Thanks.
.
Ramesh. ....etc

[:=Read Full Message Here=:]

MULITIPURPOSE ELECTONICS DEVICE AND VISITOR COUNTING SYSTEM
Mini Project done by:
Bibin Mohanan
Basha KM
Ijas

S6 ECE, College Of Engineering Trivandrum





1.INTRODUCTION
With the growing need to conserve energy, more people are becoming conscious of energy consumption and are looking for ways to reduce costly waste associated with electricity.
Though most consumers do not think about lighting until the light bulb fails or
t ....etc

[:=Read Full Message Here=:]

maharashtra sahyadri masik lottery result dated 23 rd feb 2015
Thanks
Rohan Sawant ....etc

[:=Read Full Message Here=:]

Abstract:
Present project is designed using 8051 microcontroller to avoid railway accidents happening at unattended railway gates, if implemented in spirit. This project utilizes two powerful IR transmitters and two receivers; one pair of transmitter and receiver is fixed at up side (from where the train comes) at a level higher than a human being in exact alignment and similarly the other pair is fixed at down side of the train direction. Sensor activation time is so adjusted by calculating the time taken at a certain s ....etc

[:=Read Full Message Here=:]

AUTOMATIC BUS STATION ANNOUNCEMENT SYSTEM
ANTENNA
Message section
3. WORKING EXPLANATION
The above fig shows the complete circuit diagram of automatic bus station announcement system. It consists of a transmitter, receiver (main circuit) and a message section.
Transmitter:
The transmitter circuit transmits the code of each bus from the bus. To generate the code and the address we use an encoder IC HT12E. The encoder has an 8 bit address and 4 bit data lines. Through these bits we can select any code for a bus. The ad ....etc

[:=Read Full Message Here=:]

Present project is designed using 8051 microcontroller to avoid railway accidents happening at unattended railway gates, if implemented in spirit. This project utilizes two powerful IR transmitters and two receivers; one pair of transmitter and receiver is fixed at up side (from where the train comes) at a level higher than a human being in exact alignment and similarly the other pair is fixed at down side of the train direction. Sensor activation time is so adjusted by calculating the time taken at a certain speed to cross at least one compart ....etc

[:=Read Full Message Here=:]