Genetic Algorithm for Identification of Time Delay Systems from Step Responses

presented by:
Gang-Wook Shin, Young-Joo Song, Tae-Bong Lee, and Hong-Kyoo Choi


abstraction

Abstract:
In this paper, a real-coded genetic algorithm is proposed for identification of time delay systems from step responses. FOPDT (First-Order Plus Dead-Time) and SOPDT (Second- Order Plus Dead-Time) systems, which are the most useful processes in this field, but are difficult for system identification because..............etc

[:=Read Full Message Here=:]

CHAPTER 1: INTRODUCTION
Here is an inexpensive auto cut-off circuit, which is fabricated using transistor and other discrete components. It can be used to protect loads such as refrigerator, T.V., and VCR from undesirable over and under line voltages, as well as surges caused due to sudden failure/resumption of main power supply. This circuit can be used directly as a standalone circuit between the mains supply and the load, or it may be inserted between an existing automatic/manual stabilizer and the load.
The over/u..............etc

[:=Read Full Message Here=:]

HIGH AND LOW VOLTAGE CUT OFF WITH TIME DELAY
Overview
The power line fluctuations and cut-offs causes damages to electrical appliances connected to the line. It is more serious in the case of domestic appliances like fridge and air conditioners. If a fridge is operated on low voltage, excessive current flows through the motor, which heats up, and get damaged.
The under/over voltage protection circuit with time delay presented here is a low cost and reliable circuit for protecting such equipments from damages...............etc

[:=Read Full Message Here=:]

I need the documention of two techniques for fast computation of constrained shortest path..............etc

[:=Read Full Message Here=:]

requirement if project on vibration analysis with time delay..............etc

[:=Read Full Message Here=:]

how to test definite time delay relay type vtt..............etc

[:=Read Full Message Here=:]

Abstract”
Computer supported collaborative applications on overlay networks are gaining popularity among users who are geographically dispersed. Examples of these kinds of applications include video-conferencing, distributed database replication, and online games. This type of application requires a multicasting subnetwork, using which messages should arrive at the destinations within a specified delay bound. These applications also require that destinations receive the message from the source at approximately the same time. The problem..............etc

[:=Read Full Message Here=:]

please send high low voltage cut off with time delay circuit to my mail
[email protected]

[:=Read Full Message Here=:]

Abstract
MEMS varactors are one of the important passive MEMS devices. Their applica- tions include use in VCOs, tunable impedance matching networks, tunable ¯lters, phase shifters, and true time delay lines. The shunt capacitive structure has been employed in most of the conventional MEMS varactor designs because of its simplicity. However, the capacitance ratio of this conventional shunt capacitive MEMS varactor is limited to 1.5 because of the MEMS Pull- In e®ect, which happens when the de°ection between the MEMS top and bottom m..............etc

[:=Read Full Message Here=:]

Multicast Routing with Delay and Delay Variation Constraints for Collaborative Applications on Overlay Networks

Maximum variation in the delays from a source to the destinations. The time-complexity of our Algorithm is O (|E| +nk log (|E|/n) +m2 k), where n and |E| are the number of nodes and edges in the network, respectively, k is the Number of shortest paths determined, and Abstract”Computer supported collaborative applications on overlay networks are gaining popularity among users who are geographically dispers..............etc

[:=Read Full Message Here=:]