Procedure:-
1. Rewrite the given difference equation to have only the output terms on the LHS and input terms to be on RHS
2. Create a Matrix of Y coefficients, a
3. Create a Matrix of X coefficients, b
4. Generate the input sequence x(n)
5. Find the output of the system for the input sequence x(n)
6. Plot the input and the output

MATLAB program for difference equation without initial condition
clear
close all
clc

% THE INPUT SEQUENCE IS X(N) = U(N)
% THE DIFFERENCE EQUATION IS Y(N) – 0.9Y(N-1)= X(N)
% N..............etc

[:=Read Full Message Here=:]

I would like to get the basics of Honing PPT
I would like to get the basics of Honing PPT..............etc

[:=Read Full Message Here=:]

difference between honing lapping and super finishing...............etc

[:=Read Full Message Here=:]

Presented by-
MOINUDDIN M SHIRBADGI


Abstract - Some form of simple control is needed for small induction motors. This paper proposes a simple speed control method for small induction motors using a simple calculation without the need for a speed sensor. In this method, the load torque is estimated from the detected power factor of the induction motor and the speed of the induction motor is compensated for by a frequency-boost technique. The boost frequency is selected from a data table measured before hand. Sa..............etc

[:=Read Full Message Here=:]

Plz as soon as You can Plz send me this seminar It is urgent to present..............etc

[:=Read Full Message Here=:]

i want honing of tubes by horizontal machine..............etc

[:=Read Full Message Here=:]

DIFFERENCE BETWEEN RELAY PANEL & PLC.
Relay Panel – It is an operating on analog system.
PLC – It is an operating on digital system.
Relay Panel –The maximum time any change in input is reflected in any output is t1.
PLC – The maximum time any change in input is reflected in any output is t1+t2+…+ Tn.
Relay Panel –Since this is made from analogue components. It is possible to replace. A logic section without stopping execution of other logic sections if wired correctly.
PLC – This ..............etc

[:=Read Full Message Here=:]

DESIGN AND FABRICATION OF VALVE LAPPING MACHINE..............etc

[:=Read Full Message Here=:]

Submitted by:
Mr.Pankaj Negi


Honing Technology
Introduction:-
Honing is an abrasive machining process that produces a precision surface on a metal workpiece by scrubbing an abrasive stone against it along a controlled path. Honing is primarily used to improve the geometric form of a surface, but may also improve the surface texture.
Typical applications are the finishing of cylinders for internal combustion engines, air bearing spindles and gears. Types of hone are many and various but all consist of one or..............etc

[:=Read Full Message Here=:]

difference between honing lapping and super finishing process ..............etc

[:=Read Full Message Here=:]