|
Thread / Post | Tags |
Title: IMPACT VIBRATION CONTROL USING SEMI-ACTIVE DAMPER Page Link: IMPACT VIBRATION CONTROL USING SEMI-ACTIVE DAMPER - Posted By: seminar class
Created at: Wednesday 23rd of February 2011 12:14:47 PM
| |
IMPACT VIBRATION CONTROL USING SEMI-ACTIVE DAMPER
Introduction
Dynamic vibration absorbers are used for suppressing the steady state vibration of a machine.
It consists of spring-mass-damper system.
For an impact force, it can damp only the residual part of impact vibration
But maximum amplitude of the vibration is almost remain same that of undamped vibration
DYNAMIC VIBRATION ABSORBER
RESPONSE Of An IMPULSE
FREE BODY DIAGRAM
EQUATION OF MOTION
Control force of dynamic damper can ..............etc
[:=Read Full Message Here=:]
|
|
Title: Fabrication of spring loaded fan Page Link: Fabrication of spring loaded fan - Posted By: ajith3100
Created at: Tuesday 23rd of March 2010 10:11:55 AM
| |
very good project
excellent ideas..............etc
[:=Read Full Message Here=:]
|
|
Title: Numerical Analysis Of Magnetorheological Fluid Damper Using FEM full report Page Link: Numerical Analysis Of Magnetorheological Fluid Damper Using FEM full report - Posted By: project report tiger
Created at: Thursday 04th of March 2010 01:43:42 AM
| |
MAGNETORHEOLOGICAL FLUID DAMPER
1.INTRODUCTION
Vibration isolators or dampers are commonly used to mitigate vibrations in structures or machines. The isolators are typically passive and they are designed to reduce the vibration of the most undesired frequency. However, in many applications, the excitation frequency varies across a large range. In a semi-active device, the stiffness or damping can be adjusted during operation. Changing the stiffness of the support device can be exploited by moving the eigenfrequency o..............etc
[:=Read Full Message Here=:]
|
Title: IDFD FAN LOGIC SYSTEM Page Link: IDFD FAN LOGIC SYSTEM - Posted By: smart paper boy
Created at: Wednesday 24th of August 2011 03:27:58 PM
| fd fan damper logic,
|
P&I OF BOILER AUXILLARIES A. FD FAN
START PERMISSIVES
Blade pitch position minimum.
Discharge damper fully closed.
Lube oil pressure adequate.
Control oil pressure adequate.
Oil tank level normal.
Bearing temperature not high.
One ID Fan running AND other FD fan not running.
OR Both ID Fan running
TRIPS
Fan bearing temperature very high
Post purge furnace pressure very high/ very low
Outlet damper fail to open in set time (3 min)
No ID fan running or one..............etc
[:=Read Full Message Here=:]
|
|
|
Title: SPEED CONTROL OF RADIATOR FAN USING DIFFERENTIAL GEAR ARRANGEMENT Page Link: SPEED CONTROL OF RADIATOR FAN USING DIFFERENTIAL GEAR ARRANGEMENT - Posted By: harshita tiwari
Created at: Thursday 05th of August 2010 09:28:19 PM
| |
PLEASE SEND FURTHER MORE INFORMATION ABOUT PROJECT NAMED SPEED CONTROL OF RADIATOR FAN USING DIFFERENTIAL GEAR ARRANGEMENT..............etc
[:=Read Full Message Here=:]
|
|
|
Title: design and analysis of an active damper in automobiles Page Link: design and analysis of an active damper in automobiles - Posted By: ifeanyi jude
Created at: Thursday 13th of May 2010 10:06:47 PM
| |
i am final year project college student who need help on the topic active dampers in automobile and i am expected to give a detailed report which will include supporting equations, general analysis and its application and importance in cars...............etc
[:=Read Full Message Here=:]
|
|
|
Title: temperature based fan speed controller using AT89s51 micro controller Page Link: temperature based fan speed controller using AT89s51 micro controller - Posted By: M.Ramya reddy
Created at: Friday 06th of August 2010 08:56:13 AM
| |
Hello,
This is ramya student of B.tech final year.I want ppt on
temperature based fan speed controller using AT89s51 microcontroller. i dont have any information regarding this topic.
Iam requesting you to provide ppt on my topic...............etc
[:=Read Full Message Here=:]
|
Title: friction damper used for the control of vibration in a gas- turbine blade Page Link: friction damper used for the control of vibration in a gas- turbine blade - Posted By: project report helper
Created at: Friday 01st of October 2010 07:19:10 PM
| |
P V Ramaiah J. and G Krishnaiah2
I Department of Mechanical Engineering, Srikalahasteeswara Institute of Technology, Andhra Pradesh, India 2Department of Mechanical Engineering, SV University College of Engineering, Andhra Pradesh, India
The manuscript was received on 15 June 2006 and was accepted after revision for publication on 30 May 2007. DOl: 1O.1243/09544062JMES411
abstract
The paper deals with modelling and design of a friction damper. This has been done in four phases. In the first p..............etc
[:=Read Full Message Here=:]
|
Title: Remote Fan Regulator With Timer Page Link: Remote Fan Regulator With Timer - Posted By: projects wizhard
Created at: Friday 30th of July 2010 11:25:27 PM
| |
The features of this device are:
5 speed fan regulator, Digital display, Timer, Low temperature shutdown switch and also a Buzzer
This circ uses PIC 12F675 from Microcchip and CD D4026 (De cade Counters/Dividers +
Decoded 7 Segment Display Outtputs).
How to Operate
As IR pulses are received, circuit will count up an the increase of fan speed. speed can be controlled from 0-5.current. The seleection of the user is displayed on seven segment display also for convenience.
Timer mode:
To enter timer mode go to 6..............etc
[:=Read Full Message Here=:]
|
Title: MODELLING AND DESIGN OF ROBOTIC SYSTEMS HAVING SPRING-DAMPER ACTUATORS Page Link: MODELLING AND DESIGN OF ROBOTIC SYSTEMS HAVING SPRING-DAMPER ACTUATORS - Posted By: project topics
Created at: Tuesday 20th of April 2010 06:02:29 PM
| |
Abstract
In paper the fundamental question about optimal interaction between the controlling stimuli generated by the active (powered) and the passive (unpowered) drives of the robotic systems have been studied. A mathematical statement of the problem has been proposed that is suitable to study this question for the semi-passively actuated n-degree-of-freedom robotic systems. The problem is formulated as an optimal control problem for n-degree-of-freedom mechanical system models a semi-passively actuated robot. We take into account the inter..............etc
[:=Read Full Message Here=:]
|