Smart Car Race India
#1

Presented by:
SUMAN KUMAR PANKAJ

[attachment=11214]
Smart Car Kit
► Smart Car Kit Contents
► Car Kit
► S12X Controller Board
► Sensor Board
► 7.2 Volts 2000 ma NI-Cd Battery
► 9V 2 Amps Power Supply
► Cables
Smart Car Controller
► Racing Track
► Surface of the racing track will use base material suitable for racing.
► Width of the racing track will not be less than 60 cms.
► Specific specification for material used for surface of the racing track will be provided on web site of the event
► Surface of the racing track is white, with continuous black line (25 mms. wide) drawn in the middle as the pilot line
► The minimum bending radius of the racing track will not be less than 60 cms.
► The racing track can intersect with a crossing angle of 90°
► There is a starting area of 1 mt. long in the racing track, as shown in figure below. In addition, there is a black starting line 10 cms. long at both side of the starting point. Start time and end time should be determined when front part of the racing car passes the starting line.
► Starting Point
Position Sensing Example -1
Initial Calibration

► Read Black and White value of each sensors
► Compensation Ratio = 256 / (Black value – White value)
Position Calculation
► If Reading > ‘Black value’ , Reading=Black
► If Reading < ‘White value’ , Reading=White
► Compensated reading = (Reading - White) X Compensation ratio
► Position of the center of the black line =
(Index of ‘middle sensor’) * 2 * ATD resolution level + (Largest index sensor reading – smallest index sensor reading)
► In Index of middle sensor = ‘3’
► ATD resolution level = 256 (8 bit)
► Largest index sensor reading = 156
► Smallest index sensor reading = 243
► Therefore, position = 3 * 2 * 256 + (156 - 243) = 1449
► Error = 1536-1449 =87
► Position Sensing Example -2
Racing Restrictions
► It is not allowed to change structure of the chassis, distance between wheels, radius of wheel and tire;
► It is not allowed to change the components provided in the car kit.
► It is not allowed to change drive motor and battery, the car model has to be powered by the DC motor and battery of the car model itself;
► It is not allowed to change hardware provided
► It is not allowed add any extra components
Rules for Preliminary Competition
► Two trial runs will be allowed to tune the parameters of racing car system
► There will be one racing track in the racing field.
► The racing teams racing order will be determined by drawing lot.
► In each racing round, each racing will run for two laps on the racing track. Time will be calculated when the racing car leaves the starting line. After running for two laps, racing cars should stop within the racing track in 3 meters after the starting line. Otherwise, 1 second will be added to the racing time of the car.
► Shorter time taken for a single lap will be calculated as the time for that round. The shortest time of the two rounds will be taken as the final time of the racing car.
► Based on number of participating teams, the organizing committee of the event will select certain percentage of racing teams to participate the final based on their scores in preliminary.
► The technical judgment group will perform on-site technical inspection for all the wining cars eligible for the final. Qualification for final of racing car that are not compliant with related equipment requirements (article 1 of the rule) will be cancelled and replaced by the next car;
► List of finalists will be submitted by the referee group to the organizing committee of the event for approval and announcement.
► After preliminary, car prototype and software can be improved (compliant with competition rules) but changes should be reported in the Technical Update Sheet.
Rules for Final Competition
► Two trial runs will be allowed to tune the parameters of racing car system
► The racing teams eligible for the final will be ordered based on their scores in preliminary and compete in reverse order of their scores in preliminary.
► The racing track for the final is different from that used for preliminary in shape and will be larger
► Each finalist can only compete for one time.
► Each racing will run for two laps on the racing track. Time will be calculated when the racing car leaves the starting line. After running for two laps, racing cars should stop within the racing track in 3 meters after the starting line. Otherwise, 1 second will be added to the racing time of the car.
► The shortest time taken to run a single lap will be taken as the final time of the racing car.
► Score in the preliminary will not be included in score of the final; instead, it is used only to determine racing order in final. For racing teams failed to participate or appear in time in the final will be disqualified from the final.
Failure in the Competition
► The racing car runs out of the track for more than two times;
► The player touches the racing car after beginning of the racing without consent of the referee;
► The racing car fails to pass the technical inspection after the race.
► No score will be given for a failed team.
Reply
#2

to get information about the topic SMART CAR full report related topic refer the page link bellow
http://studentbank.in/report-smart-car-race-india
Reply

Important Note..!

If you are not satisfied with above reply ,..Please

ASK HERE

So that we will collect data for you and will made reply to the request....OR try below "QUICK REPLY" box to add a reply to this page
Popular Searches: f1 race track and safety seminar, 5km race, advantages and disadvantage of race car aerodynamics, robo race track, race course for, alston race, race track memory seminar report,

[-]
Quick Reply
Message
Type your reply to this message here.

Image Verification
Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.
Image Verification
(case insensitive)

Possibly Related Threads...
Thread Author Replies Views Last Post
  smart quill full report computer science technology 20 36,103 05-08-2013, 12:00 AM
Last Post: Guest
Photo Smart Pixel Arrays Computer Science Clay 4 2,686 07-02-2013, 10:19 AM
Last Post: seminar details
Smile smart note taker seminars full report [email protected] 59 30,424 25-01-2013, 12:00 PM
Last Post: seminar details
  smart dust full report computer science technology 7 13,087 24-12-2012, 02:27 PM
Last Post: seminar details
  Smart Cameras in Embedded Systems computer science crazy 1 2,129 22-12-2012, 12:04 PM
Last Post: seminar details
  embedded systems ppt and Smart Phone full report computer science topics 5 10,357 22-12-2012, 12:03 PM
Last Post: seminar details
  smart note taker sruthi 3 5,336 07-03-2012, 09:42 AM
Last Post: seminar paper
Music Smart Sensor (Download Full Report And Abstract) computer science crazy 10 7,643 06-03-2012, 10:33 AM
Last Post: seminar paper
  A BIOMEDICAL SMART SENSOR FOR THE VISUALLY IMPAIRED seminar class 1 2,143 16-02-2012, 04:09 PM
Last Post: seminar paper
  E-Ink electronic-paper or smart-paper computer science crazy 5 4,685 14-02-2012, 10:38 AM
Last Post: seminar paper

Forum Jump: