i need a project on digit interruption counter[/font][/size]

digital interruption counter

Infrared Interruption counter (AT89C2051)

Infrared interruption counter is a reliable circuit that takes over the task of counting number of interruptions very accurately. When somebody enters into the room, then the Counter is Incremented by one. The total number of Persons inside the Room is displayed on the seven segment displays.The microcontroller does the above job it receives the signals from the sensors, and this signals operated under the control of software which is stored in ROM.All the above systems are controlled by the Microcontroller. In our project we are using the popular 8 bit microcontroller AT89C2051. It is a 20 pin microcontroller.

Object counter using 8051 microcontroller.
This article is about a simple object counter/visitor counter using 8051 microcontroller . AT89S51 belonging to the 8051 family is the microcontroller used here. This circuit can count the number of objects passing across a line , number of persons passing through a gate/door and so on. The can be simply divided into two sections i.e. the sensor section and the display section.

Sensor.

The sensor part consists of a ultra bright led (with focus), and LDR, opamp LM324 and the associated passive components. The LED is placed on one side of the door and the LDR is placed on the other side so that the light from the LED falls directly on the LDR.As you know, the resistance of the LDR has an inverse relationship with the intensity of the light falling on it. The preset resistor R14 is so adjusted that the voltage across the LDR is below 1.5V when it is illuminated. This voltage (labelled A in the circuit diagram) is connected to the inverting input of the opamp which is wired as a comparator with reference voltage 1.5V (set using R15 and R16).Capacitor C1 is meant for bypassing noise or anything like that which may cause false triggering.Resistor R13 is meant to control the current through the LED.

When the light is falling on the LDR the voltage across it will be less than the reference voltage and so the output of the opamp remains high. When the light beam is interrupted, the voltage across the LDR goes above the reference voltage and so the opamp output goes low and it indicates a pass.