[attachment=12601]
INTRODUCTION-:
This Project can be used in houses and offices in which more than one telephone is connected in parallel through a single telephone line Our project is used to connect a maximum of four telephones in parallel. When any one of the phone is lifted, all the other lines are disconnected from the telephone line.
The above condition is also applicable when the telephone ring arrives only one telephone which is connected to the telephone line which is lifted first, while the other three lines are disconnected from the telephone line.
All the functions are controlled by the 8 bit Microcontroller AT89C2051 which has a ROM of 2 Kilobytes
A BRIEF INTRODUCTION TO ATC2051 MICROCONTROLLER:
The AT89C2051 is a low-voltage, high-performance CMOS 8-bit microcomputer with 2K bytes of Flash programmable and erasable read-only memory (PEROM). The device is manufactured using Atmel’s high-density nonvolatile memory technology and is compatible with the industry-standard MCS-51 instruction set. By combining a versatile 8-bit CPU with Flash on a monolithic chip, the Atmel AT89C2051 is a power-ful microcomputer which provides a highly-flexible and cost-effective solution to many embedded control applications. The AT89C2051 provides the following standard features: 2K bytes of Flash, 128 bytes of RAM, 15 I/O lines, two 16-bit timer/counters, a five vector two-level interrupt architecture, a full duplex serial port, a precision analog comparator, on-chip oscillator and clock circuitry. In addition, the AT89C2051 is designed with static logic for opera-tion down to zero frequency and supports two software selectable power saving modes. The Idle Mode stops the CPU while allowing the RAM, timer/counters, serial port and interrupt system to continue functioning. The power-down mode saves the RAM contents but freezes the oscillator disabling all other chip functions until the next hardware reset
PIN DIAGRAM-:
FEATURES
• Compatible with MCS®-51Products
• 2K Bytes of Reprogrammable Flash Memory – Endurance: 10,000 Write/Erase Cycles
• 2.7V to 6V Operating Range
• Fully Static Operation: 0 Hz to 24 MHz
• Two-level Program Memory Lock
• 128 x 8-bit Internal RAM
• 15 Programmable I/O Lines
• Two 16-bit Timer/Counters
• Six Interrupt Sources
• Programmable Serial UART Channel
• Direct LED Drive Outputs
• On-chip Analog Comparator
• Low-power Idle and Power-down Modes
• Green (Pb/Halide-free) Packaging Option
BLOCK DIAGRAM-:
THEORY-:This circuit provides secrecy when two or more telephones are connected in parallel to a telephone line. The circuit also prevents incoming calls to as well as outgoing calls from other telephones connected in parallel, except from the one lifted first.
When someone picks up the handset of the telephone connected in parallel to the original (master) phone for making an outgoing call, no dial tone is heard and the phone appears to be dead. But when a call comes, the ring signal switches the SCRs ‘on’ and conversation can be carried out. As soon as the handset is kept on the hook, the SCR goes off and the telephone can again only receive incoming calls.
When a call comes, conversation can be made only from the telephone which is lifted up first. To carry out conversation from the other telephone, the handset of the telephone that was lifted up first has to be placed on the hook and then the push-to-on switch of the associated circuit of the other telephone has to be pressed after lifting up its handset. Thus the circuit ensures privacy because both the telephones cannot be active at the same time.
Those who are don’t need parallel telephones can rig up the associated circuit of a single telephone to work as an outgoing call preventer. An outgoing call can be made only when one lifts up the handset and presses the push-to-on switch of its associated circuit.
The polarity of the telephone line can be determined by a multimeter. To avoid confusion, a bridge rectifier can be used at the input of the circuit.