automatic voltage regulator write up
#1

Kindly give give me some write up on automatic voltage regulator
Mr bunmi
Reply
#2


To get information about the topic design and construction of automatic voltage regulator full report ppt and related topic refer the page link below


http://studentbank.in/report-literature-...#pid181018
Reply
#3
details about

Basic of automatic voltage regulator

13/08/2011 by Lemau 17 Comments


Basically the AVR or Automatic Voltage Regulators function for generator is to ensure voltage generated from power generator running smooth to maintain the stable voltage in specified limit. It can stabilize the voltage value when suddenly change of load for power supply demand.

If the generator running in parallel condition,the AVR can controlled the voltage that it produce to ensure of equal value for reactive load sharing.

For the big system of interconnected power distribution with parallel design,it must have a full controlled and transient stability particular must added for requirement to the Automatic Voltage regulator for generator.

What is Automatic Voltage Regulator (AVR)

The AVR can operated in two condition controlled.It is from manual control or automatic control with standard limited parameter that required for generator.

This controlled must be provided if it not available for the generator system to ensure it smooth running without any problem.



Basic principles for AVR


A signal proportional to generator terminal voltage obtained from the rectified output of a voltage transformer is compared to a stabilized reference voltage obtained within the regulator.

If it detected any abnormal,different or error signal, it will amplified and control the excitation supply, increase or decrease the input to the main field winding or exciter field.The main purpose is to reduce the error signal to zero or an acceptable value.

Adjustment of the set voltage is obtained either by adjustment of the reference voltage or by adjusting the proportion of machine voltage compared to the reference voltage. The stabilizing loop is included to prevent hunting.Below is basic diagram for AVR circuit.

VOLTAGE REGULATOR

A voltage regulator is designed to automatically maintain a constant voltage level. A voltage regulator may be a simple "feed-forward" design or may include negative feedback control loops. It may use an electromechanical mechanism, or electronic components. Depending on the design, it may be used to regulate one or more AC or DC voltages.

Electronic voltage regulators are found in devices such as computer power supplies where they stabilize the DC voltages used by the processor and other elements. In automobile alternators and central power station generator plants, voltage regulators control the output of the plant. In an electric power distribution system, voltage regulators may be installed at a substation or along distribution lines so that all customers receive steady voltage independent of how much power is drawn from the line.

Electronic voltage regulators

A simple voltage/current regulator can be made from a resistor in series with a diode (or series of diodes). Due to the logarithmic shape of diode V-I curves, the voltage across the diode changes only slightly due to changes in current drawn or changes in the input. When precise voltage control and efficiency are not important, this design may work fine.

Feedback voltage regulators operate by comparing the actual output voltage to some fixed reference voltage. Any difference is amplified and used to control the regulation element in such a way as to reduce the voltage error. This forms a negative feedback control loop; increasing the open-loop gain tends to increase regulation accuracy but reduce stability. (Stability is avoidance of oscillation, or ringing, during step changes.) There will also be a trade-off between stability and the speed of the response to changes. If the output voltage is too low (perhaps due to input voltage reducing or load current increasing), the regulation element is commanded, up to a point, to produce a higher output voltage–by dropping less of the input voltage (for linear series regulators and buck switching regulators), or to draw input current for longer periods (boost-type switching regulators); if the output voltage is too high, the regulation element will normally be commanded to produce a lower voltage. However, many regulators have over-current protection, so that they will entirely stop sourcing current (or limit the current in some way) if the output current is too high, and some regulators may also shut down if the input voltage is outside a given range (see also: crowbar circuits).

DC voltage stabilizers

Many simple DC power supplies regulate the voltage using either series or shunt regulators, but most apply a voltage reference using a shunt regulator such as a Zener diode, avalanche breakdown diode, or voltage regulator tube. Each of these devices begins conducting at a specified voltage and will conduct as much current as required to hold its terminal voltage to that specified voltage by diverting excess current from a non-ideal power source to ground, often through a relatively low-value resistor to dissipate the excess energy. The power supply is designed to only supply a maximum amount of current that is within the safe operating capability of the shunt regulating device.

If the stabilizer must provide more power, the shunt regulator output is only used to provide the standard voltage reference for the electronic device, known as the voltage stabilizer. The voltage stabilizer is the electronic device, able to deliver much larger currents on demand.

Reply

Important Note..!

If you are not satisfied with above reply ,..Please

ASK HERE

So that we will collect data for you and will made reply to the request....OR try below "QUICK REPLY" box to add a reply to this page
Popular Searches: automatic voltage regulator write up, 2kva automatic voltage regulator write up,

[-]
Quick Reply
Message
Type your reply to this message here.

Image Verification
Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.
Image Verification
(case insensitive)

Possibly Related Threads...
Thread Author Replies Views Last Post
  automatic timetable generator source code vb 1 7,525 07-04-2017, 12:31 PM
Last Post: jaseela123d
  what we write in jagran com column in yuva sampadak paper 3 1,632 27-02-2017, 12:56 PM
Last Post: jaseela123d
Music automatic differential unit locking system report pdf 4 1,474 15-02-2017, 12:02 PM
Last Post: jaseela123d
  automatic wiper using 555 timer ppt 2 1,091 08-02-2017, 10:18 PM
Last Post: Ansel janson
  multi channel voltage scanner ashishsharma8619 3 2,159 27-10-2016, 03:48 PM
Last Post: jaseela123d
  automatic chocolate vending machine in embedded system case study 1 1,194 13-08-2016, 12:29 PM
Last Post: jaseela123d
  source code in c for automatic irrigation system using 8051 2 962 03-08-2016, 10:53 AM
Last Post: seminar report asees
  automatic toll collection system using rfid viva questions 2 922 23-07-2016, 10:10 AM
Last Post: jaseela123d
  automatic streetlight on off with sms controlling and failure detection with indication 2 727 22-07-2016, 02:52 PM
Last Post: jaseela123d
  advantages disadvantages of arduino automatic plant watering system 2 983 21-07-2016, 03:24 PM
Last Post: dhanabhagya

Forum Jump: