i want project details

[attachment=8968]
CONTROLLING ELECTRICAL APPLIANCES USING A PC
This is a circuit for using the printer port of a PC, for control application using software and some interface hardware. The interface circuit shown in the figure is drawn for only one device, being controlled by D0 bit at pin 2 of the 25-pin parallel port. Identical circuits for the remaining data bits D1 through D7 (available at pins 3 through 9) have to be similarly wired. The use of opto-coupler ensures complete isolation of the PC from the relay driver circuitry.
Lots of ways to control the hardware can be implemented using software. In C/C++ one can use the outportb(portno,value) function where portno is the parallel port address (usually 378hex for LPT1) and 'value' is the data that is to be sent to the port. For a value=0 all the outputs (D0-D7) are off. For value=1 D0 is ON, value=2 D1 is ON, value=4, D2 is ON and so on. eg. If value=29(decimal) = 00011101(binary) ->D0,D2,D3,D4 are ON and the rest are OFF.

to get information about the topic pc based home appliance controlling full report ,ppt and related topic refer the page link bellow


http://studentbank.in/report-%09pc-based...rol-system

http://studentbank.in/report-home-applia...through-pc

http://studentbank.in/report-sms-based-w...iances-and

http://studentbank.in/report-appliances-...ull-report