DCN LAN Switch
Introduction
This Installation and Configuration Instruction describes how to install the DCN
LAN Switch (DLS) in a 19” rack and how to set up, configure and maintain
the DLS.
The DLS is a wide-range powered 8-port Ethernet switch with support for
power-over-Ethernet (PoE) on one port. The DLS is intended to be used to
connect devices on a local site LAN to the DCN via, for example, the NPU of a
MINI-LINK TN node.
The DLS can be manually configured in a flexible way to support various
Ethernet communicat ....etc

[:=Read Full Message Here=:]

PRESENTED BY
AZEEZ OLAREWAJU LAWAL


CHAPTER 1
INTRODUCTION
A traffic light is a collection of two or more coloured lights found at some junctions and pedestrian crossings which indicates whether it is safe and/or legal to continue across the path of other road users. In the United Kingdom, traffic lights are widely used both on major roads and in built-up areas. Their numbers have increased exponentially since they were first invented in 1868.
The operation of standard traffic lights which are currently depl ....etc

[:=Read Full Message Here=:]

Luminescence from Surfactant-Free ZnO Quantum Dots
Prepared by Laser Ablation in Liquid
R. S. Ajimsha, G. Anoop,
*
Arun Aravind, and M. K. Jayaraj
z
Optoelectronic Devices Laboratory, Department of Physics, Cochin University of Science and Technology,
Kochi-682 022, Kerala, India
Highly transparent, luminescent and biocompatible ZnO quantum dots were prepared in water, methanol, and ethanol using
liquid-phase pulsed laser ablation technique without using any surfactant. Transmission electron microscopy analysis confirmed
the formation ....etc

[:=Read Full Message Here=:]

what is fdi in hindi ....etc

[:=Read Full Message Here=:]

Electrical Characteristics of n-ZnO/p-Si Heterojunction Diodes
4
Grown by Pulsed Laser Deposition at Different Oxygen
5
Pressures
6
7
R.S. AJIMSHA,
1
M.K. JAYARAJ,
1,3
and L.M. KUKREJA
2
8
1.”Optoelectronics Devices Laboratory, Department of Physics, Cochin University of Science and
9
Technology, Kochi 682022, India. 2.”Laser Materials Processing Division, Raja Ramanna Centre
10
for Advanced Technology, Indore 452013, India. 3.”e-mail: [email protected]
11
Heterojunction diodes of n-type ZnO/p-type silicon (1 ....etc

[:=Read Full Message Here=:]

DESIGN OF BOILER STACK
ABSTRACT
Chimney, which form the last component of a system using a flue gas such as feoiler, IC engines, play a vital role in maintaining efficiency, draft, etc, of a system and also in minimizing the atmospheric pollution.
The boiler plant of HOCL had used LSHS (low Sulphur heavy stock) as a fuel. Recently they changed the fuel to LSFO (low Sulphur furnace oil). As a combined effect of increased corrosion rate and natural calamities the stack had undergone failure. As per the Kerala State Polluti ....etc

[:=Read Full Message Here=:]

Electrical Characteristics of n-ZnO/p-Si Heterojunction Diodes
4
Grown by Pulsed Laser Deposition at Different Oxygen
5
Pressures
6
7
R.S. AJIMSHA,
1
M.K. JAYARAJ,
1,3
and L.M. KUKREJA
2
8
1.”Optoelectronics Devices Laboratory, Department of Physics, Cochin University of Science and
9
Technology, Kochi 682022, India. 2.”Laser Materials Processing Division, Raja Ramanna Centre
10
for Advanced Technology, Indore 452013, India. 3.”e-mail: [email protected]
11
Heterojunction diodes of n-type ZnO/p-type silicon (1 ....etc

[:=Read Full Message Here=:]

1
Calories: -
Protein: .03 gm
Carbohydrates: .50 gm
Fiber: - gm
Total fats: .00 gm
Saturated fats: 0 gm
Unsaturated fats: .002 gm
Cholesterol: 1 mg



1. 1 teaspoon

Vitamin Content

1 USRDA
Vitamin A: 8 5000 IU
Thiamine: .002 1.7 mg
Vitamin B-2: .002 1.7 mg
Vitamin B-6: .004 2.0 mg
Vitamin B-12: 0 6 mcg
Biotin: - 300 mcg
Niacin: .018 20 mg
Pantothenic Acid: .010 10 mg
Folic acid: - 400 mcg
Vitamin C: 2.7 60 mg
Vitamin E: - 30 IU



1. 1 teaspoon

Mineral Content

1 USRDA
Calcium: 3 1000 mg
Copper: - 2 m ....etc

[:=Read Full Message Here=:]

1.Fillet gauges are available in standard radii from
A) 1.55 mm to 12 mm
B) 2.5 mm to 3.5 mm
C) 1 mm to 2 mm
D) 3.5 mm to 4 mm

2.The cutting edges need to be honed with special grinding stricks called
A) Oxide grinding wheel
B) Aluminium Oxide wheel
C) Honing strick
D) Carbide grinding strick

3.Form tools have a much longer cutting edge than
A) Special turning tool
B) Ordinary turning tool
C) Facing tool
D) Turning tool

4.This method of marking is used on
A) Datum line method 
B) Centre line metho ....etc

[:=Read Full Message Here=:]

i looking this paper every week karmasangsthan e paper
....etc

[:=Read Full Message Here=:]