i need a water level detector circuit using 89c51 which can also detect the level of water and control the motor.the codes are also needed, ( in C ) ....etc

[:=Read Full Message Here=:]

Shridhan Drum Scale liquid level indicator is a mechanical device to measure the level of liquids stored. ....etc

[:=Read Full Message Here=:]

SHRIDHAN manufactures products that are customized to the need of the customer. Different products have different dimensions, length and physical features. ....etc

[:=Read Full Message Here=:]

Embedded c program for water level indicator using LPC2148 ....etc

[:=Read Full Message Here=:]

Water Level Indicator With Alarm


Here is a simple, versatile circuit
which indicates the level of
water in a tank. This circuit produces
alarm when water level is below
the lowest level L1 and also when water
just touches the highest level L12. The
circuit is designed to display 12 different
levels. However, these display levels
can be increased or decreased depending
upon the level resolution required. This
can be done by increasing or decreasing
the numb ....etc

[:=Read Full Message Here=:]

Choosing a Microcontroller
 As it provides on chip microprocessor, RAM, ROM, Parallel I/O port, Serial I/O port etc. hence its cost is less, size is less, power consumption is less and speed is more.
 Software development tools like assembler, C compilers etc are easily available and are easy to upgrade.
....etc

[:=Read Full Message Here=:]

INTRODUCTION
 Water resources are the sources of water , only 1% of water is potentially utilized by human beings.
 Project deals with conserving water in overhead tanks.
 Water level in the over head tank is continuously displayed on LCD.
 Motor is automatically controlled according to the level of the water.
 Manual switching of motor is carried by using keypad.
BLOCK DIAGRAM
MICRO CONTROLLER
 A microcontroller is a general purpose device, but that is meant to re ....etc

[:=Read Full Message Here=:]

Hi am geeth i would like to get details on source code for water level indicator using verilog ..My friend Justin said source code for water level indicator using verilog will be available here and now i am living at colombo and i last studied in the college/school university and now am doing ....i need help on ......etc ....etc

[:=Read Full Message Here=:]

This water-level indicator uses a 7-segment display, instead of LEDs, to indicate the water level (low, half and full) in the tank. Moreover, a buzzer is used to alert you of water overflowing from the tank. The circuit shows the water level by displaying L, H and F for low, half and full, respectively. The circuit uses five sensors to sense the different water levels in the tank. Sensor A is connected to the negative terminal (GND) of the power supply. The other four sensors (B through E) are connected to the inputs of NOT gate IC 7404. When ....etc

[:=Read Full Message Here=:]

give information and project report on it
....etc

[:=Read Full Message Here=:]