SIR I UREGENTLY NEED BLOCK DIAGRAM OF THIS PROJECT IMMEDIATELY.PLEASE SIR.SEND IT TO ME AS FAR AS POSSIBLE TO mail:
[email protected]
from saikumar ....etc

[:=Read Full Message Here=:]

I need Programming of this project if possible send me the software recquirements of this project
....etc

[:=Read Full Message Here=:]

By:
P. Kedar Nath
(08MPE016)
M.Tech- PED




OBJECTIVE
to generate the sinusoidal signals using FPGA .
to generate the Triangular signals using FPGA .
to generate the sinusoidal PWM signals using FPGA (Xilinx FPGA SPARTAN 3, XC3S400)
to control the speed of BLDC motor using sinusoidal PWM Technique.

Work completed so far:-
Introduction of FPGA
Introduction of VHDL
Flow Ch ....etc

[:=Read Full Message Here=:]

Dear sir,
Would you please like to send me some materials regarding power point slides for voice enabled speed control dc motor so that i can conduct my project related to this topics.

with thanks-
Arif Ahammad ....etc

[:=Read Full Message Here=:]

please sent full report of sms based dc motor speed and direction control ....etc

[:=Read Full Message Here=:]

I am in need of detailed project material about pwm based speed control of dc motor using 8052 controller. ....etc

[:=Read Full Message Here=:]

INTRODUCTION
This assignment is basically designed to demonstrate the use of controllers in DC motor which consists of two stage ,electronic stage that is controlled by 8 bit microcontroller and second is the mechanical stage consisting of gear box which controls the motion of DC motor to provide a impulse to electronic stage which generates a resultant signal to control the parameters of controller.
FEEDBACK-CONTROL THEORY
Figure 1 shows th ....etc

[:=Read Full Message Here=:]

ABSTRACT

Stepper motor rotate by applying sequence of pulses to the stepper Motor coils. Speed of the motor is based on the sequence of pulses to the motor. Direction can be change by changing the pulse sequence inversely. Here in this project pulse is getting from PIC Microcontroller. It’s a Programmable Peripheral Interface controller. Here keypad, Stepper motor Driver both are interfaced with the PIC Microcontroller. Keypad is used to vary the speed and to change the direction Of the stepper motor.

Controller output is given i ....etc

[:=Read Full Message Here=:]

K.Naga Sujatha, Dr.K.Vaisakh and Anand.G

Abstract
This paper presents a control scheme combined with neural network, fuzzy controller and PI- controller for the brushless DC motor. The neural network control learned continuously and gradually becomes the main effective control. Performances of the proposed neural network are compared with the corresponding fuzzy PI controller and conventional PI controller. Matlab/simulink software was used to simulate the proposed scheme. Neural network improves speed response and ....etc

[:=Read Full Message Here=:]

pls send the details of the project topics ....etc

[:=Read Full Message Here=:]