ABSTRACT


C3D or constellation 3Dâ„¢s innovative technology enables the recording,reading and storing of information on many layers within a storage media.Flourescent materials are embedded in the pits and grooves of each layer of the media and information is then stored and retrieved using the principles of fluorescence ,instead of optical reflection as currently used with CDs and DVDs .The media can be produced in card or disk format of any size. This technology holds the promise of exciting new applications and vas ....etc

[:=Read Full Message Here=:]

The SMILE project is developing a new type of messaging middleware system to simplify integration of distributed enterprise applications. Currently, many enterprises use publish-subscribe, request-reply and queuing messaging technologies to glue together their distributed applications into a complex, expensive and virtually unmanageable bodies of code. The vision with SMILE is to give enterprise developers a higher level model for programming and managing distributed messaging systems “ a way to specify a system in terms of what , but not ....etc

[:=Read Full Message Here=:]

BLANK SIZE OF HEMI SPHERICAL DISHED END 1524MM IDX57MM THK.
BLANK SIZE OF TORISPHERICAL DISHED END SIZE 1524MM IDX85MM THK ....etc

[:=Read Full Message Here=:]

CHAPTER 1: INTRODUCTION
Here is an inexpensive auto cut-off circuit, which is fabricated using transistor and other discrete components. It can be used to protect loads such as refrigerator, T.V., and VCR from undesirable over and under line voltages, as well as surges caused due to sudden failure/resumption of main power supply. This circuit can be used directly as a standalone circuit between the mains supply and the load, or it may be inserted between an existing automatic/manual stabilizer and the load.
The over/u ....etc

[:=Read Full Message Here=:]

Actually i am doing project on reduction in thickness variation of dished end. so if you know from where i can start please help..thank you ....etc

[:=Read Full Message Here=:]

CHAPTER 1
ABSTRACT
This is a new technique for the protection of transmission systems by using the global positioning system (GPS) and fault generated transients. In this scheme the relay contains a fault transient detection system together with a communication unit, which is connected to the power line through the high voltage coupling capacitors of the CVT. Relays are installed at each bus bar in a transmission network. These detect the fault generated high frequency voltage transient signals and record the time instan ....etc

[:=Read Full Message Here=:]

DESIGN OF PRESSURE VESSEL

ABSTRACT
This project work deals with a detailed study and design procedure of pressure vessel. A detailed study of various parts of pressure vessels like shell, closure, support, flanges, nozzles etc. Design is carried according to rules of ASME code section VIII, Division I.
The first chapter deals with detailed study of pressure vessel i.e. the various materials used in pressure construction and temperature are mentioned .It also deals with the study of various parts like flanges, support e ....etc

[:=Read Full Message Here=:]

Abstract

An electromagnetic generator without moving
parts includes a permanent magnet and a magnetic core including first
and second magnetic paths. A first input coil and a first output coil
extend around portions of the first magnetic path, while a second input
coil and a second output coil extend around portions of the second
magnetic path. The input coils are alternatively pulsed to provide
induced current pulses in the output coils. Driving electrical current
through each of the input coils reduces a level of flux from the
per ....etc

[:=Read Full Message Here=:]

What is T L and W L in dish end of vessels/exchangers and what is its significance and importance ....etc

[:=Read Full Message Here=:]

FAILURE ANALYSIS OF SHELL AND TUBE HEAT EXCHANGER
PROJECT REPORT
Submitted by
ALEX BABY ARUN M V JAIN RAJ .V VIJEESH VIJAYAN
ABSTRACT
Tar column recoiled E4509 in the phenol plant of HOCL found failed in service un like any other exchanger s in phenol manufacturing process .Each failure very high cost to HOCL in terms of production loss due to down time for maintence and due to the loss of therminol liquid to the process .the loss due to each failure found to be nearly RS 1.5 chore >the cost of tube bundle in SS-316 is ....etc

[:=Read Full Message Here=:]

Peripheral Nerve Injury and Repair
Alisha Asif & Reshma Nair U
BT & BCE, MCET-Trivandrum



Abstract
Peripheral nerve injuries are common, and there is no easily available formula for successful treatment.
Incomplete injuries are most frequent. Seddon classified nerve injuries into three categories:
neurapraxia, axonotmesis, and neurotmesis. After complete axonal transection, the neuron undergoes a
number of degenerative processes, followed by at ....etc

[:=Read Full Message Here=:]

Deisel Genrator set overview
Engine Operation : 4 Stroke Diesel Engine
1. The intake stroke starts at TDC and ends at BDC. The intake valve opens during this stroke to admit fresh air into the combustion chamber. The intake valve closes at BDC.
2. The compression stroke starts at BDC and ends at TDC. The air is compressed to a small fraction of its initial volume. Compression ratio is about 17:1. Due to high compression, the air temp. increases.
3. Fuel is injected into the combustion chamber in the form of a fine ....etc

[:=Read Full Message Here=:]