BADARPUR THERMAL POWER STATION


INTRODUCTION

BTPS was conceived in 1965 to meet the growing electricity demand of Northern Region.

The site construction activities started in 1968.

The plant became operational with the commissioning of its first unit on 26th July 1973, 2nd unit in ;74 , 3rd unit in ’75 , 4th unit in ’78 & 5th unit in ’81.


Maintenance Management System
Objective:Maximizing Availability Through:
Identifying ....etc

[:=Read Full Message Here=:]

thermal power station



INTRODUCTION


A thermal power station is a power plant in which the prime mover is steam driven. Water is heated, turns into steam and spins a steam turbine which drives an electrical generator. After it passes through the turbine, the steam is condensed in a condenser and recycled to where it was heated; this is known as a Rankine cycle. The greatest variation in the design of thermal power station ....etc

[:=Read Full Message Here=:]

SUBMITTED BY:
APARAJITA KATIYAR


INTRODUCTION
In India there is a very long chain of thermal power project including the project in UP. Some of the power projects under Uttar Pradesh Rajya Vidyut Utpadan Nigam Ltd. (UPRVUNL) are as follows:
Panki Thermal Power Station:
With the industrial development of Kanpur, a thermal power station was established at the banks of river Ganga, in the year 1923, which was known as “Riverside Power House” (RPH). In the year 1947, RPH was taken over by the Government of ....etc

[:=Read Full Message Here=:]

FEROZE GANDHI UNCHAHAR THERMAL POWER STATION



INTRODUCTION OF NTPC

Established in 1975, NTPC the largest power company of the country has been consistently powering the growth of India.

With an installed capacity of 30,144 MW, it contributes 28.6% of the nation’s power generation with only 18.79% of India’s total installed capacity. An ISO 9001:2000 certified company, it is world’s sixth largest thermal power generator and second most efficient in capacity utiliz ....etc

[:=Read Full Message Here=:]

SURATGARH SUPER THERMAL POWER STATION


Suratgarh Super Thermal Power Station is owned by Rajasthan Rajya Vidhyut Utpadan Nigam Ltd. and is situated near village Raiyanwali about 25 KM from Suratgarh town, an ideal location for setting up a thermal power station in the state having regards to the availability of land, water, transmission network proximity to broad gauge railway and being an important load centre for north west Rajasthan. The techno-economic clearance for the ....etc

[:=Read Full Message Here=:]

what is the turn over of kota super thermal power station ....etc

[:=Read Full Message Here=:]

KOTA SUPER THERMAL POWER STATION



INTRODUCTION


It was established in 1973 , comprising of 2 units of each of capacity 110 MW.
It is located at the left bank of the CHAMBAL River at the upstream of KOTA BAIRAJ.
1st & 2nd units are of 110 MW each.
3rd ,4th &5th units are of 210 MW .
6th & 7 unit of 195 MW.
Total generation capacity (110+110+210+210+210+195+195) =1240 MW
Favorable condition
Abundant quantity of clean cooling water.
Good transport ....etc

[:=Read Full Message Here=:]

SUBMITTED BY:
SALMAN KHAN


INTRODUCTION
Panipat Thermal Power Station is a project of Haryana Power Generation Company Limited (HPGCL) situated in Panipat Jind road at about 11 kms from Panipat Bus Stand.
Panipat Thermal Power Station (PTPS) has a total installed generation capacity of 1367.8 MW comprising of four Units of 110 MW each( unit1 uprated to 117.8 MW ) , two Units of 210 MW each and two Units of 250 MW each. As all the balance of plant facilities viz. Coal Handling Plant, Ash Handling Plant, C ....etc

[:=Read Full Message Here=:]

INTRODUCTION


For the power generation with 2x110 MW and 3x210 MW of K.T.P.S. authorities are required to be operative to active full operation. The auxiliaries are basically operation either on L.T. System i.e. 415 V 3 ? power supply is made available to the system after providing the station transformer of 3x50 MVA capacity with voltage 220 KV/ 7.2/7.2 KV & different service transformers of capacity 1.0 MVA , 1.5 MVA , 2.0 MVA , which are located near the load centre as the transformer having the voltage of 6.6 KV /415 V. The 6.6 KV pow ....etc

[:=Read Full Message Here=:]

THERMAL POWER STATION

The basic energy cycle involved in the plant is as follows :

Chemical Energy ---> Mechanical Energy ---> Electrical Energy

Turbine
Turbine converts the heat energy of the steam into mechanical energy.

The super heated steam works on the blades of the turbine and hence the blades starts rotating to produce the mechanical energy.
1) High pressure turbine.
2) Intermediate Pressure turbine.
3) Low pressure turbine.





....etc

[:=Read Full Message Here=:]