A candidate-set-free algorithm for generating D-optimal split-plot designs


Introduction
Split-plot designs arise in experimental studies when a completely randomized run order
is structurally impossible, expensive or inconvenient. So, a statistician’s recommendation
to randomize the order of the runs is often ignored in practice. Instead the experimenter
rearranges the runs of the design so that hard-to-change factors only need to be changed a
few times ....etc

[:=Read Full Message Here=:]

This version of project makes use of RTDX with MATLAB for transferring data from the DSK to the PC host. This section introduces configuration file(.CDB) file and RTDX with MATLAB.
This project uses source program spectrogram_rtdx_mtl.c that runs on the DSK which computes 256 point FFT and enables an RTDX output channel to write/send the resulting FFT data to the PC running MATLAB for finding the spectrogram. A total of N/2 (128 points )are sent. The (.CDB) configuration file is used to set interrupt INT11. From this configuration file select ....etc

[:=Read Full Message Here=:]

Hi i am unable to get the output images for k means algortihm.would anybody able to help me to fix this issue ....etc

[:=Read Full Message Here=:]

I am looking for matlab code shadow detection and removal in rgb images using matlab, anybody can help me? ....etc

[:=Read Full Message Here=:]

entropy coding after quantization ....etc

[:=Read Full Message Here=:]

hi i need matlab code for hydrothermal scheduling ....etc

[:=Read Full Message Here=:]

B = FIR1(N,Wn) designs an N'th order lowpass FIR digital filter
and returns the filter coefficients in length N+1 vector B.
The cut-off frequency Wn must be between 0 < Wn < 1.0, with 1.0
corresponding to half the sample rate. The filter B is real and
has linear phase, i.e., even symmetric coefficients obeying B(k) =
B(N+2-k), k = 1,2,...,N+1.
If Wn is a two-element vector, Wn = , FIR1 returns an
order N bandpass filter with passband W1 < W < W2.
B = FIR1(N,Wn,'high') designs a highpa ....etc

[:=Read Full Message Here=:]

clc;
ccsboardinfo %board info
cc=ccsdsp('boardnum',0); %set up CCS object
reset(cc); %reset board
visible(cc,1); %for CCS window
enable(cc.rtdx); %enable RTDX
if ~isenabled(cc.rtdx);
error('RTDX is not enabled')
end
cc.rtdx.set('timeout',50); %set 50sec timeout for RTDX
open(cc,'spectrogram1.pjt'); %open CCS project
load(cc,'./debug/spectrogram1.out'); %load executable file
run(cc); %run program
configure(cc.rtdx,2048,1); %configure one RTDX channel
open(cc.rtdx,'ochan','r'); %open output ch ....etc

[:=Read Full Message Here=:]

matlab code for implementation of csma cd in matlab ....etc

[:=Read Full Message Here=:]

Thanks for your code............................................................ ....etc

[:=Read Full Message Here=:]