please help me to design and set up a circuit for dual axis solar tracker withiut using microcontroller.... ....etc

[:=Read Full Message Here=:]

Submitted by
Romy Kansal

Under Esteemed Guidance of
Mr. MANDEEP SINGH



Abstract
The following document details the research and development of an Automatic Solar radiation tracker. Fossil fuels are a relatively short-term energy source; consequently, the uses of alternative sources such as solar energy are becoming more wide spread. To make solar energy more viable, the efficiency of solar array systems must be maximized. A feasible approach to maximizing the efficiency of solar array systems is ....etc

[:=Read Full Message Here=:]

need report on this project,very urgently ....etc

[:=Read Full Message Here=:]

The ARM7TDMI Datasheet

ARM(v4T) ISA Features
Predicated Instruction
Conditional Instruction
Features rarely seen on other architectures
PC can be destination of data operating instructions
Load/Store Multiple
Multiple Operating Modes
Hardwired Banked Registers in each mode
General Purpose Registers
Program Status Registers
Dual ISA
ARM ISA mode
THUMB ISA mode
ARM ISA: Predicated Instruction
Why predicated instruction?
To eliminate conditional branch in small if-then-else
Limitations?
In ....etc

[:=Read Full Message Here=:]

Prepared by:
Thanh Phu Nguyen




Abstract

“Solar Panel Maximum Power Point Tracker”. As the name implied, it is a photovoltaic system that uses the photovoltaic array as a source of electrical power supply and since every photovoltaic (PV) array has an optimum operating point, called the maximum power point, which varies depending on cell temperature, the insolation level and array voltage. A maximum power point tracker (MPPT) is needed to operate the PV array at its maximum power poi ....etc

[:=Read Full Message Here=:]

i want to design Solar home lighting system with Sun Tracker as my final year engineering project anyone can help me plz ???
my email is [email protected] ....etc

[:=Read Full Message Here=:]

i have attached a solar tracking report i read on the internet. wanting to implement this project as my final year project, i want some help in the fuzzy logic design. i some how didnot understand how it is used and how it can be implemented.

pooja

P.S: i need help ASAP ....etc

[:=Read Full Message Here=:]

This project is designed to monitor the LPG leakage or smoke and activate the siren and auto dialer using ARM based microcontroller. LPG Sensor is used to sense the leakage. A buzzer is provided to alert the user in abnormal condition.
The LPC2148 are based on a 16/32 bit ARM7TDMI-S™ CPU with real-time emulation and embedded trace support, together with 128/512 kilobytes (kB) of embedded high speed flash memory. A 128-bit wide memory interface and a unique accelerator architecture enable 32-bit code execution at maximum ....etc

[:=Read Full Message Here=:]

A new control scheme for a single ? phase diode clamped rectifier is proposed to achieve a unity power factor, balanced neutral point voltage and constant DC-bus voltage. Four power switches are used in the rectifier to generate a three-level PWM wave form on the rectifier terminal voltage.

The line current command is derived from a DC-link voltage regulator and an output power estimator. The hysteresis current Controller is used to track the line current command. To balance the neutral-point voltage, a capacitor voltage compensator is emplo ....etc

[:=Read Full Message Here=:]

Hey there Everyone, the information i am looking forward is the Solar Maximum Power Point Tracker for my project. I need prepare a report & the hardware implementation is from my end. So any information in this project will be appreciated.



Advance Thanks. ....etc

[:=Read Full Message Here=:]