SYNOPSIS
In the present scenario of automobile industry manufacturers are trying to produce comfortable and safe vehicles which the consumers are looking for. A shock absorber is a damping element of the vehicle suspension, and its performance directly affects the comfortability, dynamic load of the wheel and dynamic stroke of the suspension. The conventional type of shock absorbers has got the main drawback that it causes foaming of the fluid at high speeds of operation. This results in a decrease of t ....etc

[:=Read Full Message Here=:]

I'm studing Electrical engineering in Kerala. I want to do a project on shock gaurd.
It must protect human from shock hazards at the same time the power supply must not cut off.

I think it can be done using the detection of resistance of human body and other electric componets (Always human body have more resistsnce).So we can add a unit in the power supply, that detects resistance and prevent current flow through the component of resistance larger than certain limit.

Please give me suggestion, if my idea has any defe ....etc

[:=Read Full Message Here=:]

INTRODUCTION
The meaning of the term earthing or grounding is to connect the electrical equipment to the general mass of earth by wire of negligible resistance. This brings the body of the electrical equipment to Zero potential and thus will avoid the shock to the operator. The neutral of the supply system is also solidly earthed to ensure its potential equal to Zero according to Indian Electricity Eale,[?The earthed or connected with earth means connected with the general mass of the earth in such manner as to sure at ....etc

[:=Read Full Message Here=:]

SYNOPSIS
The main condition that all countries have agreed about the future of the earth is to keep it clean and free of pollution .The solution is to use alternate fuels and among them Hydrogen would be a good choice. Hydrogen can be produced in different ways. Hydrogen should be produced in such a way to obtain maximum efficiency and should be at a affordable cost. Various strategies are adopted to obtain the above conditions. There are different methods for Hydrogen storage and distribution and variou ....etc

[:=Read Full Message Here=:]

Definition

The fiber/matrix adhesion is most likely to control the overall mechanical behavior of fiber-reinforced composites. An interfacial reaction may result in various morphological modifications to polymer matrix microstructure in proximity to the fiber surface. The interactions between fiber and polymer matrix during thermal conditioning and thermal shock are important phenomena.

Thermal stresses were built-up in glass fiber reinforced epoxy composites by up-thermal shock cycles (negative to positive temperature exposure) for diff ....etc

[:=Read Full Message Here=:]

ELECTRONIC SHOCK ABSORBER
INTRODUCTION
Shock absorbers must absorb or dissipate energy. One design consideration, when designing or choosing a shock absorber is where that energy will go. In most dashpots, energy is converted to heat inside the viscous fluid. In hydraulic cylinders, the hydraulic fluid will heat up, while in air cylinders, the hot air is usually exhausted to the atmosphere. In other types of dashpots, such as electromagnetic ones, the dissipated energy can be stored and used later.
DESCRIPTION[/ ....etc

[:=Read Full Message Here=:]

GAS SHOCK ABSORBER

INTRODUCTION
The ohline product brand of shock absorbers is one of the oldest - the manufacturer invented the twin tube shock - and whether fitted to a new car at the factory, or as a replacement component during its life.
The shock absorber is an integral part of the car's safety, and having shocks in good condition is just as important as having good brakes, tyres and active safety systems such as ABS and EPS.
Whether when braking, cornering, driving in the wet, on snow, in windy condit ....etc

[:=Read Full Message Here=:]

Thermal shock on interfacial adhesion of thermally conditioned Glass fiber/epoxy


The fiber/matrix adhesion is most likely to control the overall mechanical behavior of fiber-reinforced composites. An interfacial reaction may result in various morphological modifications to polymer matrix microstructure in proximity to the fiber surface. The interactions between fiber and polymer matrix during thermal conditioning and thermal shock are important phenomena.

Thermal stresses were built-up in glass ....etc

[:=Read Full Message Here=:]

....etc

[:=Read Full Message Here=:]

send me the seminar report in full of nitro shock absorber ....etc

[:=Read Full Message Here=:]