Construction material subjected to repetitive or cyclic loading have to be qualified for their fatigue behaviour. Generally their behaviour is considered satisfactory if they withstand two million cycle of repetitive loading without distress or failure at that required mean stress level and range stress.
The recent research in reinforcing Portland cement based material with randomly distributed fibres was spurred by pioneering research or fibre reinforced concrete (FRC) conducted in the United state in the 1960s.The addition of fibre in the co ....etc

[:=Read Full Message Here=:]

i am b.tech student needed seminar report on deep brain simulation
....etc

[:=Read Full Message Here=:]

Hi am deekshant i would like to get details on seminar report on deep web pdf ..My friend chetan said seminar report on deep web pdf will be available here and now i am living at ......... and i last studied in the college/school ......... and now am doing ....i need help on ......etc ....etc

[:=Read Full Message Here=:]

Presented by:
S.KAVITHA


Strengthening Of CorrosionInflicted RC Beams Using FRP Wrap
Objective
The loss of stiffness caused by corrosion regained by FRP application
Confine concrete and improve the compressive strength
Decreased corrosion rates due to FRP application
Substantial increase in the ultimate strength
Stress-strain curves for FRP products
Properties of FRP composites
Corrosion damage of a concrete beam
Methodology
Experimental programme
Corrosion infliction
Process of inducing c ....etc

[:=Read Full Message Here=:]

ABSTRACT
This paper presents the results of experimental studies concerning the flexural strengthening of RC beams using externally bonded Slurry Infiltrated Mat CONcrete (SIMCON) laminates. A total of four reinforced concrete beams were cast and tested in the laboratory over an effective span of 3000 mm. Three beams were strengthened with bonded SIMCON laminate at the bottom under virgin condition and tested until failure; the remaining one beam was used as control specimen. Static responses of all the beams w ....etc

[:=Read Full Message Here=:]

I want to know about the deep beams & would like to give seminar ....etc

[:=Read Full Message Here=:]

Construction material subjected to repetitive or cyclic loading have to be qualified for their fatigue behaviour. Generally their behaviour is considered satisfactory if they withstand two million cycle of repetitive loading without distress or failure at that required mean stress level and range stress.
The recent research in reinforcing Portland cement based material with randomly distributed fibres was spurred by pioneering research or fibre reinforced concrete (FRC) conducted in the United state in the 1960s.The addition of fibre in the co ....etc

[:=Read Full Message Here=:]

Deflection of beams
Abstract
The basic aspects of Probe Beam Deflection techniques, used to detectconcentration gradients in electrochemical systems, are described.
The different techniques is first discussed. Then, a critical review of published applications of the techniques to various electrochemical systems is performed. Among the systems whom these techniques has been applied are: electrochromic oxides, conducting polymers, redox polymers, underpotential deposition, surface electrochemical reaction on solid ele ....etc

[:=Read Full Message Here=:]

Presented by:
M. Sekar, L.M.Poornima


The high cost of conventional building materials is a major factor affecting housing delivery in world. This has necessitated research into alternative materials of construction. The project paper aims at analyzing flexural and compressive strength characteristics of concrete produced using crushed, granular coconut as substitutes for conventional coarse aggregate with partial replacement using M30 grade concrete. Beams are casted, tested and their physical an ....etc

[:=Read Full Message Here=:]

Fatigue Behavior of Reinforced Concrete Beams Strengthened with Different FRP Laminate Configurations
Synopsis: This paper presents testing results of thirteen small-scale beams
strengthened using carbon fiber-reinforced polymer composites tested under repeated
loads to investigate their fatigue behavior. The beams were strengthened using
different thicknesses and widths of composite laminates to identify parameters that
would generate different failure modes. Two predominant fatigue failure modes were
identified through these tes ....etc

[:=Read Full Message Here=:]