I WANT A PPT ON 3D PRINTING PEN DOODLER OF MINIMUM 8 SLIDES. IT WILL BE HELPFUL IF SEND IT TO MY MAIL ADDRESS([email protected]).
IT WILL BE THANKFUL TO YOU. ....etc

[:=Read Full Message Here=:]

As IT environments become more diverse and geographically dispersed, intelligent server rack management solutions provide IT professionals with the information and tools necessary to manage and maintain operations. These solutions leverage hardware and/or software to monitor and control server-level power state and condition. In this article, a distributed architecture that allows remote control and monitoring of PC. Internet communications is relied on socket programming. EAD is used for network communications via the TCP/IP ....etc

[:=Read Full Message Here=:]

I want to know more details of 3d printing.so please provide me it's seminar report and ppt ....etc

[:=Read Full Message Here=:]

1.1 volt is equal to :
(A)One coulomb per second
(B)One joule per coulomb
(C )One coulomb per joule
(D)Work done is transfering a charge of one coulomb

2.Theresistance of a conductor increases as its:
(A)Gross sectional area decreases
(B)Length decreases
(C )Resistivity decreases
(D)length is reduced and cross sectional area is increased

3.A 3phase load is balanced, if all the 3 phases have the same :
(A)impedance
(B)Power factor
(C )impedance and power factor
(D)None of the above

4.Candela is the unit ....etc

[:=Read Full Message Here=:]

Abstract
The Network Printer Management System (NPMS) automate the process of printing and accounting. Basically it allows the legitimate users to accesses the printer from anywhere in the campus. Besides that it acts as a medium to control the operations of the users.
....etc

[:=Read Full Message Here=:]

Hi...... im looking to send data to print from PC to printer using RF modules.. i want to interface microcontroller to printer and i need all the circuits and software to make this possible....kindly help ....etc

[:=Read Full Message Here=:]

Introduction
The PC parallel port is a powerful platform, though inexpensive, for implementing projects dealing with the control of real-world peripherals. It can be used to control the printer as well as household and other electrical appliances.
The computer program included as part of the project controls relays through the interface circuit, which, in turn, switch the appliances ‘on’ or ‘off’. The parallel port has 12 outputs including 8 data lines and 4 control lines.
The hardware circuit developed ca ....etc

[:=Read Full Message Here=:]

Prepared by:
MUHAMMAD NASIRUDDIN MAHYUDDIN


Introduction

The first step is to determine tha control. The purpose of the control law is to allow us to assign a set of pole locations for the closed-loop system that will correspond to satisfactory dynamic response in terms of rise time and other measure of transient response.
Then, secondly, we show how to introduce the reference input with full-state feedback. We describe the process of finding the poles for good design. In the second step, If t ....etc

[:=Read Full Message Here=:]

....etc

[:=Read Full Message Here=:]

PRINTER

WHAT IS PRINTER?

A printer is an output device that produces text and graphics on paper. 
Many printers are primarily used as local peripherals, and are attached by a printer cable or, in most newer printers, a USB cable to a computer which serves as a document source.
In addition, a few modern printers can directly interface to electronic media such as memory card, or to image capture devices such as digital camera.


....etc

[:=Read Full Message Here=:]