any one please sent ppt presentation for thermo electric air cooling for cars
....etc

[:=Read Full Message Here=:]

ABSTRACT
A new generation of small scale (less than 20 MWe) biomass fueled, power plants are
being developed based on a gas turbine (Brayton cycle) prime mover. These power plants
are expected to increase the efficiency and lower the cost of generating power from fuels
such as wood. The new power plants are also expected to economically utilize annual
plant growth materials (such as rice hulls, cotton gin trash, nut shells, and various straws,
grasses, and animal manures) that are not normally considered as fuel for power plants.
This p ....etc

[:=Read Full Message Here=:]

i am rahul , doing M.Tech from SVNIT surat. i know the basics of EGR of gas turbine engines. i want the full project report ....etc

[:=Read Full Message Here=:]

a power point presentation on an Indian gas power plant ....etc

[:=Read Full Message Here=:]

Please provide the matter on high performance material used in stem and gas turbines. ....etc

[:=Read Full Message Here=:]

Hi I'm Mohamed Mahmoud working as Lab scientist and I'm preparing presentation about GC and I need some animation to make it easier.
please send it to my email
[email protected] ....etc

[:=Read Full Message Here=:]

SYNOPSIS
An alternative configuration for a regenerative gas turbine engine cycle is presented that yields higher cycle efficiencies than either simple or conventional regenerative cycles operating under the same conditions. The essence of the scheme is to preheat compressor discharge air with high temperature combustion gases before the latter are fully expanded across the turbine. The efficiency is improved because air enters the compressor at a higher temperature, and hence heat addition in the co ....etc

[:=Read Full Message Here=:]

sir i need abstract on structural and thermal analysis on turbine ....etc

[:=Read Full Message Here=:]

The gas turbine has been an enormously successful power plant for aircraft and marine propulsion, and electric power generation, due to its lightweight, smooth and reliable operation, low emissions, and varied applications. Nevertheless, it is not very efficient in converting fuel energy to useful work, due to fundamental thermodynamic limitations imposed by turbo machinery technology.

In recent years, there is renewed interest in the potential high efficiency of alternative thermodynamic cycles and unsteady combustion systems for propul ....etc

[:=Read Full Message Here=:]

....etc

[:=Read Full Message Here=:]