sir i am k.venkatesh doing a project on analysis of leaf springs, i want the properties of steel materials and the complete details of the project. i am doing REPLACING THE UP-TURN EYE OF A LEAF SPRING WITH BERLIN EYE. please give details about the properties of steel materials too. ....etc

[:=Read Full Message Here=:]

GAS SPRINGS
ABSTRACT
Gas springs provide controlled motion and speed for elements, such as lids and doors, that open and close. The absorption or damping action for gas springs can be compression or extension. In a compression gas spring the shock absorption or dampening occurs in the compression direction. In an extension gas spring the shock absorption or dampening occurs in the extension direction. Important physical specifications for gas springs include the cylinder diameter or maximum width, the rod diameter, mounting, and body materi ....etc

[:=Read Full Message Here=:]

To find the stiffness of closed helical spring ....etc

[:=Read Full Message Here=:]

GAS SPRINGS
SEMINAR REPORT
Submitted by
BIBIN BABU
S7M1, Roll No: 27113
Department Of Mechanical Engineering
College of Engineering, Thiruvananthapuram – 16
October, 2010

ABSTRACT
A gas spring is a type of spring that, unlike a typical metal spring, uses a compressed gas, contained in a cylinder and compressed by a piston, to exert a force. Gas springs are used in automobiles, where they are used to support the weight of doors while they are open. They are also used in furnit ....etc

[:=Read Full Message Here=:]

i am looking for industrial training ppt for btech cse student ppt done training from tata cmc on java. ....etc

[:=Read Full Message Here=:]

i am b.e. mechanical student,i need seminar & ppt on composite leaf springs ....etc

[:=Read Full Message Here=:]

An ideal artificial hand should match the requirements of prosthetics and humanoid robotics.

It can be wearable by the user which means that it can be perceived as part of the natural body and should replicate sensory-motor capabilities of the natural hand. However ,such an ideal bionic prosthesis is still far from reality.

This paper describes the design and fabrication of a novel artificial hand based on a biomechatronic and cybernetic approach. The approach is aimed at providing natural sensory-motor co-ordination, biomimetic mechanis ....etc

[:=Read Full Message Here=:]

Presented by:
Jeong Sik Yim
Heong Kook Joo
Dong Seong Sohn


ABSTRACT

The holddown Spring is one of the major components of a fuel assembly for PWR. It holds the fuel assembly firmly seated down on the lower core plate and allows the FA axial movement caused from the irradiation growth of guide thimbles. Depending on the up-lift force of a fuel assembly, from 2 to 4 leaves are assembled to be a set of a spring pack and it is fixed on the frame of the top end piece by screw. The spring can deflect so greatly during operat ....etc

[:=Read Full Message Here=:]

INTRODUCTION
Gas springs provide controlled motion and speed for elements, such as lids and doors, that open and close. They typically rely on the fluid dampening of a gas such as nitrogen in the cylinder. Important performance specifications for gas springs include absorber stroke, compressed length, extended length, maximum force (P1), and maximum cycles per minute
The absorption or damping action for gas springs can be compression or extension. In a compression gas spring the shock absorption or dampening occurs in the compressio ....etc

[:=Read Full Message Here=:]

seminar report of 3d solar cell technology,ppt,advantages, ....etc

[:=Read Full Message Here=:]