A High-SpeedLow-Power Multiplier Using an Advanced Spurious Power Suppression Technique


Abstract”
This study provides the experience of applying an advanced version of our former Spurious Power Suppression Technique (SPST) on multipliers for high-speed and low-power purposes. To filter out the useless switching power, there are two approaches, i.e. using registers and using AND gates, to assert the data signals of multipliers after the data transition. The simulation results show that the SPST implementation wit ....etc

[:=Read Full Message Here=:]

Abstract:

This project provides the experience of applying an advanced version of Spurious Power Suppression Technique (SPST) on multipliers for high speed and low power purposes. When a portion of data does not affect the final computing results, the data controlling circuits of SPST latch this portion to avoid useless data transition occurring inside the arithmetic units, so that the useless spurious signals of arithmetic units are filter out. Modified Booth Algorithm is used in this project for mul ....etc

[:=Read Full Message Here=:]

sir,
i want the complete design of Electrical Power Generation using Steam Power Plant. ....etc

[:=Read Full Message Here=:]

POWER QUALITY MEASUREMENTS PERFORMED ON
WIND FARMS IN TURKISH POWER SYSTEM
ABSTRACT
The wind farm integration may cause power quality concerns in power systems.
Integration of large scale wind farms into power systems presents some challenges
that must be addressed such as system operation and control, system stability, and
the power quality. Therefore, determining how much the power quality would be
affected by fluctuant power production and by the connection of the wind turbines
to the power system is the most important issue ....etc

[:=Read Full Message Here=:]

This seminarsr provides the experience of applying an advanced version of our former spurious power suppression technique (SPST) on multipliers for high-speed and low-power purposes. To filter out the useless switching power, there are two approaches, i.e., using registers and using AND gates, to assert the data signals of multipliers after the data transition. The SPST has been applied on both the modified Booth decoder and the compression tree of multipliers to enlarge the power reduction. The simulation results show that the SPST implementat ....etc

[:=Read Full Message Here=:]

ABSTRACT


Beamed micro wave power transmission may be thought of as extending our two dimensional power transmission networks to the three dimensional power transmission system in which power is beamed from earth to space or power collected in space is beamed back to the earth.

Solar energy is an unlimited source of energy. The electrical energy obtained from the sun by satellites in geostationary orbits is transmitted to earth. Unlike x-rays or ultra-violet radiation, microwaves are non-ionizing and are o ....etc

[:=Read Full Message Here=:]

INTRODUCTION
A major problem facing Planet Earth is provision of an adequate supply of clean energy. It has been that we face ...three simultaneous challenges -- population growth, resource consumption, and environmental degradation -- all converging particularly in the matter of sustainable energy supply. It is widely agreed that our current energy practices will not provide for all the world's peoples in an adequate way and still leave our Earth with a livable environment. Hence, a major task for the new century will be to dev ....etc

[:=Read Full Message Here=:]

Abstract”
This paper presents a simplified sinusoidal uninterruptible power supply (UPS) system. The proposed scheme includes features such as high power factor, low total harmonic distortion and good dynamic response at the ac output voltage. In addition, the scheme has the desirable characteristics of high efficiency, simple circuit and low cost compared with a traditional standalone multiple stages UPS with power factor correction. The paper also presents the circuit operation, the analysis and, experimental results of the proposed U ....etc

[:=Read Full Message Here=:]

BEAMED POWER TRANSMISSION FROM SOLAR POWER SATELLITES ....etc

[:=Read Full Message Here=:]

Complementary MOS fabrication



CMOS Technology depends on using both N-Type and P-Type devices on the same chip.
The two main technologies to do this task are:
P-Well (Will discuss the process steps involved with this technology)
The substrate is N-Type. The N-Channel device is built into a P-Type well within the parent N-Type substrate. The P-channel device is built directly on the substrate.
N-Well
The substrate is P-Type. The N-channel device is built directly on the substrate, while the P-channel device is ....etc

[:=Read Full Message Here=:]