Instrumentation that converts the signal to engineering units must know a few things about what parameters to expect from the sensor. That's because full-scale range, sensitivity, connection schemes, and other factors all vary greatly from one kind of sensor to another. The end result is that it takes some effort to match up sensors with monitoring electronics. This configuration process may be no big deal when there are only a few sensors involved. But it can be problematic when gangs of sensors get wired into multichannel measurement systems. ....etc

[:=Read Full Message Here=:]

Setting up of wireless sensor network using Pervcomm



Project abstract :this project of aime Setting up of wireless sensor network using Pervcomm WS-101 wireless sensor actuator nodes to monitor the temperature in different parts of a building and developing a GUI based application which would detect certain events. Performance comparison of various routing protocols through simulation and proposing a new protocol for improved performance ....etc

[:=Read Full Message Here=:]

A plug-n-play web sensor based on a web service approach is described in this paper. It utilizes the extensible markup language to exchange information and adopting a low-cost hardware. Here , the web service technology is first introduced. There is a problem of the dynamic services and the solution to it is discussed. The solution which is proposed is such that an overview of the state of connected sensors and of the available services. When a new sensor is attached to the network, its status is displayed automatically. The metrological moni ....etc

[:=Read Full Message Here=:]

:):-/:blush::s:dodgy::idea::huh::heart:: ....etc

[:=Read Full Message Here=:]

Hi,
I m sajal. Circuit diagram of CDG 61 (O/C-E/F-O/C) will be required for modification of panel, 415V 3Ph, 4W, 50 Hz system. Please send this urgently.

thanks for co-operation,

SAJAL SENGUPTA
86979 34209 / 74394 99409 ....etc

[:=Read Full Message Here=:]

The term Plug-and-Play (PnP) has various meanings. In the broad sense it is just auto-configuration where one just plugs in a device and it configures itself. With the addition of Device Plug and Play (PnP) capabilities to the operating system it became a great deal easier to setup, configure, and add peripherals to a PC. Universal Plug and Play (UPnP) extends this simplicity to include the entire network, enabling discovery and control of devices, including networked devices and services, such as network-attached printers, Internet gateways, a ....etc

[:=Read Full Message Here=:]

jkhjffk ljfdlf jlasflfg gldfgjfl fdjgigfdigj idfg djg fdijgldfgdf fidlgjdfgl fijgldfjgdsfoi dfigldfj dflgjlidfgj fljglj ldifgldfgj gildfg ljfld ....etc

[:=Read Full Message Here=:]

about cdg61 relay time setting multiplier pdf ....etc

[:=Read Full Message Here=:]

Power
Power sources include:

On-board or out-board rechargeable energy storage system (RESS)
Gasoline or Diesel fuel
Hydrogen
Compressed air
Liquid nitrogen
Human powered e.g. pedaling or rowing
Wind
Compressed or liquefied natural gas
Solar
Waste heat from internal combustion engine. This can be converted to steam or electricity to increase vehicle propulsion. The extra power may also be used for supplemental systems
Coal, wood, Bio char or other solid combustibles
Electromagnetic ....etc

[:=Read Full Message Here=:]

sir we are using cdg61 relay vertical mounting. it has 10-terminals at the bottom & 10-terminals at the top. pls send me the wiring diagram. my email id is [email protected]; ....etc

[:=Read Full Message Here=:]