Introduction

This assignment aims at making the students familiar with the reactive (on-demand) routing protocols used in ad hoc networks and compare the performance of DSR and AODV protocols.

Performance Metrics used

We will evaluate the routing protocols in terms of two metrics-
1. Packet Delivery Fraction/Ratio : It is the ratio of packets delivered to that transmitted by the source.
2. Routing Load : It is the number of routing packets sent per data packet delivered.
NS2 Instructions

1. Get the tcl script from here.
2. This ....etc

[:=Read Full Message Here=:]

Hello , i'm working on VANET project with ( OLSR , DSR and AODV ) routing protocols . i want to enhancement the performance of these routing protocol according to PDR , Packet loss , Drop packet .. So which parameters need to change and test it to give enhancement and where is should edit it ( is the edit will be in the ini file ) .... I'm using OMNET++ 4.6 with sumo ..

Thanks in advance ....etc

[:=Read Full Message Here=:]

PERFORMANCE COMPARISON OF AODV AND DSR ROUTING PROTOCOLS IN MANETs

Thesis report submitted in partial fulfillment of the requirements for the
award of degree of
Master of Engineering
in
Software Engineering
By
Ripan Kumar
(Roll No. 8043119)
Under the supervision of
Mr. Anil Kumar Verma
MAY 2006
COMPUTER SCIENCE & ENGINEERING DEPARTMENT
THAPAR INSTITUTE OF ENGINEERING & TECHNOLOGY
(DEEMED UNIVERSITY)

COUNTERSIGNED BY
Dr. (Mrs.) Seema Bawa Dr. T. P. Singh
Head of Department Dean
Computer Science & ....etc

[:=Read Full Message Here=:]

Abstract
An Ad-Hoc network is a collection of wireless mobile nodes dynamically forming a temporary network without the use of any evolving network infrastructure or centralized administration. Due to the limitations of the wireless environment it may be necessary for one mobile node to enlist the need of other hosts in forwarding a packet to its destination. Thus multiple network hops may be needed for one node to exchange data with another across the network. For this purpose a routing protocol is used to discover routes between these nodes ....etc

[:=Read Full Message Here=:]

i want to performance enhancements and input measurement of aodv,dsr,olsr,dsdv and individual advantages and disavantages plz given to me. ....etc

[:=Read Full Message Here=:]

Performance Evaluation of Efficient and Reliable Routing Protocols for Fixed-Power Sensor Networks

ABSTRACT
A Fixed–power wireless sensor networks are cost effective and prevalent, and they are facing lots of problems like RF interference, node failure from environmental noise and energy constraints. A routing protocol for Fixed – power wireless sensor networks must overcome these problems. Because it have to achieve reliability, energy efficiency and scalability in message delivery. In this paper, we propose an efficient ....etc

[:=Read Full Message Here=:]

plz describe the modules of th topic ....etc

[:=Read Full Message Here=:]

Abstract Grid computing has recently migrated from traditional high performance and distributed computing to pervasive and utility computing based on the advanced capabilities of the wireless networks and the lightweight, thin devices. This has as result the emergence of a new computing paradigm which is the Mobile Grid. This paper presents the simulation results in order to choose the best routing protocol to give the highest performance when implement the routing protocols in the target mobile grid application. The simulations comparing thre ....etc

[:=Read Full Message Here=:]

PLEASE SEND ME THE NS2 SOURCE CODE FOR BLACK HOLE DETECTION USING AODV PROTOCOL FOR MANETS ....etc

[:=Read Full Message Here=:]

Comparative Analysis of two routing protocols DSDV and OLSR taking into account some suitable
parameters (connectivity, reliability and recovery from failures, mobility management, performance
etc.). Most importantly you need to comment on the scalability of each protocol i.e. their behavior in
dense network e.g. with more than 100 nodes in one network. ....etc

[:=Read Full Message Here=:]