Design and Development of Transient Network Analyzer



Abstract

In this thesis an attempt has been made to simulate a scaled down long transmission line hardware module to study transients. a PSPICE simulated model has also been done. Simulation for an ideal surge and a practical surge for open circuit and surge impedance loading of the line has been done on the transient network analyzer and PSPICE model.


What is TNA


The TNA is designed specially for the r ....etc

[:=Read Full Message Here=:]

WIRELESS POWER TRANSMISSION
1. INTRODUCTION
In the age of wireless communication and portable music players the demand for powering those devices wirelessly is ever prevalent. The advantages of portability and wireless communication are greatly hindered by the fact that the devices themselves must be plugged into the walls to charge. The next generation in portable devices is a device that receives power wirelessly. The first step in wireless power is providing power to a computer charging pad wirelessly. The market for ....etc

[:=Read Full Message Here=:]

INTRODUCTION
The Simulation Program with Integrated Circuit Emphasis (SPICE) circuit simulation tool was first developed in the early 1970s. It was written in the FORTRAN programming language and was intended to support the early data entry methods of this period. SPICE was immediately valuable to allow circuit designers to analyze circuit systems, in particular as the complexity of circuits began to expand with the arrival of the first integrated circuits. It is certainly one of the most important tools in Electrical Engineering and i ....etc

[:=Read Full Message Here=:]

D. Menniti, A. Pinnarelli
Electronic, Computer and System Science Department

U. De Martinis, A. Andreotti
Electric Engineering Department


Abstract –
Flexible AC Transmission Systems (FACTS) use power electronic components to enhance controllability and capability of electrical power system. FACTS devices are able of opportunely modify voltage, phase angle and/or impedance and then the power flows at particular points in power systems . One of the more intriguing and potentia ....etc

[:=Read Full Message Here=:]

Introduction
The basic Frequency Modulation communications system has:
1) Transmitter, which is the sub-system that takes the information signal and processes it prior to transmission. The transmitter modulates the information onto a carrier signal and broadcasts it over the channel
2) Channel: The medium which transports the modulated signal to the receiver. In this project, LED will be connected to FM transmitter end. Signals then will be picked up by the Photo Detector diode right before the FM Receiver
3) ....etc

[:=Read Full Message Here=:]

Presented By
Madan Gopal Rao .C


Development of a Vehicle Control Unit of a Drive By Wire system for conversion of a BMP2 Tank into a teleoperated & autonomous vehicle

Introduction
Unmanned Vehicles or Robots increase the effectiveness of the armed forces by reducing the exposure of personal to dangerous and hazardous conditions.
Hence Conversion of the BMP2 into an autonomous un-manned teleoperated vehicle.
What is the difference between teleoperated and autonomous?
Teleoperated : Indicates op ....etc

[:=Read Full Message Here=:]

ABSTRACT

This paper presents a new 3-level, single-phase, pulse width modulated (PWM), boost-integrated acto- dc series resonant converter (SRC) with high frequency transformer isolation. This converter uses a new gating scheme suitable for integrating boost converter and PWM 3-level dc-to-dc SRC converter with above resonance operation. Principle of operation and different operating modes are presented with analysis. Based on the analysis design example of a 1 HP, 280 V, 50 kHz ac-to-dc series resonant conv ....etc

[:=Read Full Message Here=:]

Hello,

I am Suki, currently studying in BCU which is located in Birmingham,UK in BEng Electronic Engineering.

I am doing my project entitled Near Field Communication. I am currently under my deep investigation regarding this title. I have found a ppt that relates to this project, but I really want to know, what type of software can be used in order to design the circuit, because, while I am designing my circuit in Orcad pspice, some of the component needed for NFC are unavailable in Orcad pSpice.

Therefore, I really hope that somebody ....etc

[:=Read Full Message Here=:]

Hello,

I am Suki, currently studying in BCU which is located in Birmingham,UK in BEng Electronic Engineering.

I am doing my project entitled Near Field Communication. I am currently under my deep investigation regarding this title. I have found a ppt that relates to this project, but I really want to know, what type of software can be used in order to design the circuit, because, while I am designing my circuit in Orcad pspice, some of the component needed for NFC are unavailable in Orcad pSpice.

Therefore, I really hope that somebody ....etc

[:=Read Full Message Here=:]

1. GSM BASED ELECTRICAL BILLING AND CUT-OFF SYSTEM

2. SMS BASED FIELD AUTOMATION

3. AUTOMISED JACQUARD POWER LOOM

4. ECONOMICAL ALCOHOL BREATH ANALYSER

5. BLIND ASSISTING DEVICE

6. WIRELESS TILT JOYSTICK

7. ULTRASONIC ANTI-CRASHING SYSTEM

8. WIRELESS WEATHER STATION MONITORING SYSTEM USING GSM

9. ROBOTIC ARMY SURVEILLANCE ....etc

[:=Read Full Message Here=:]