import java.awt.*;
import javax.swing.*;
import java.awt.event.*;
/*


*/

public class JLabelDemo extends JApplet implements ItemListener,ActionListener
{
JTextField jtf;
public void init()
{
Container contentpane = getContentPane();
contentpane.setLayout(new FlowLayout());
ImageIcon ii = new ImageIcon(ashtaal.jpg);
JButton jb = new JButton(ii);
jb.setActionComman ....etc

[:=Read Full Message Here=:]

Differential Amplifier Stages - Outline



Linear amplifier layouts:
The practical ways of puttinginputs to,
and taking outputs from,
transistors to form linear amplifiers
There are 12 choices: three
possible nodes to connect to
the input, and for each one,
two nodes from which to take
an output, and two choices of
what to do with the remaining
node (ground it or connect it
to something).
Not all these choices work
well, however. In fact only
three do.

Linear amplifier layouts:
The ....etc

[:=Read Full Message Here=:]

i want this topic can u help me pls ....etc

[:=Read Full Message Here=:]

Voice over Multiprotocol Label switching
Challenges in IP network
 Shortest path is followed in IP network
 Load sharing is not possible
 Congestion is created in IP network
 Routing in network layer
 Processing is slow and delay is more
SOLUTION TO THE PROBLEM ?
MPLS
• Multi protocol label switching
• Reduces excessive delay
• Instead of shortest follows suitable path on the basis of constraint
• Reduce packet loss
• Provide TE
• Provide QOS ....etc

[:=Read Full Message Here=:]

ABSTRACT
In IP routing each packet travels from one router to the next, each router makes an independent forwarding decision for that packet. That is each router analyses packet header, and each router runs a network layer routing algorithm. Each router independently chooses a next hop for the packet, based on its analysis and the results of running the routing algorithm.
In conventional IP forwarding a particular router will typically consider two packets to be in the same FEC(forward equivalence class) if there i ....etc

[:=Read Full Message Here=:]

hello, am Donad i request for seminar template becos i have a seminar to presedt, i would like to know many chapters consitutes a seminar andhow its looks like.
Please your response is urgently needed.. ....etc

[:=Read Full Message Here=:]

Generator & Switchyard system operation Presentation outline
SEAL OIL SYSTEM CHARGING
• Commissioning of seal oil system will be required when the
1) generator to be filled with hydrogen or air.
2) machine to be put on barring gear
• Prior to commissioning make sure that all instruments and devices are ready for operation after calibration, overhauling and trial.
SEAL OIL SYSTEM CHARGING
• Seal oil system has to be filled with oil
• Prerequisite for oil filling
1) set all level switches
2) clo ....etc

[:=Read Full Message Here=:]

pseudocode for label propagation algorithm ....etc

[:=Read Full Message Here=:]

Dynamic resource sharing protection
using label stacking and burst multiplexing
in optical burst switched networks


Abstract: A protection and restoration mechanism is essential to provide reliable traffic transmission in networks, but it is not easy to apply existing protection mechanisms to optical burst-switching (OBS) networks, because of the unique properties of OBS. The authors introduce a 1:1 link-based protection ....etc

[:=Read Full Message Here=:]

In early 1997, the Internet Engineering Task Force (IETF) established the Multi-protocol Label Switching (MPLS) working group to produce a unified and interoperable multilayer switching standard as each vendor (Cisco Systems, Lucent, and so on) developed a proprietary multilayer switching solution, maintaining the IP control component and label-swapping components in different ways. The majority of these multilayer switching solutions required an ATM transport because they could not operate over mixed media infrastructures, su ....etc

[:=Read Full Message Here=:]