The two divergent paths of Microcontroller and DSP may cross occasionally with each performing both tasks. Barriers to entry depend on peripherals, filling the data pipe, and quality of development tools. Designers of today's emerging systems that require both real-time control as well as analog signal processing are looking for ways to reduce cost and speed development time in a market that becoming increasingly competitive.

Both technical and personal considerations rule. For a microcontroller engineer to consider a DSP or for a DSP engine ....etc

[:=Read Full Message Here=:]

Submitted in Partial fulfillment of requirement for
the award of B.Tech degree
Name-RIPUDAMAN SINGH


ABSTRACT

The 8051 is one of the most popular microcontrollers in use today. Many derivative microcontrollers have since been developed that are based on—and compatible with--the 8051. Thus, the ability to program an 8051 is an important skill for anyone who plans to develop products that will take ....etc

[:=Read Full Message Here=:]

Common Base Amplifiers
Uses the same stabilised bias scheme as CE configuration.
Uses the same stabilised bias scheme as CE configuration.
The base is grounded for a.c. signals using a large capacitor.
Signal input at the emitter (between the emitter and the common base)
Signal output at the collector (between the collector and the common base)
....etc

[:=Read Full Message Here=:]

AUTHORS:
R.Sridevi,

&

E.Prasoona,
Final year, B.E (ECE)
Sir C.R.R COE, Eluru.
SIR C R REDDY COLLEGE OF ENGINEERING, ELURU
Department of Electronics & Communications Engineering


VEHICLE MONITORING AND CONTROL SYSTEM USING MICROCONTROLLERS
ABSTRACT:

It is observed that most of the accidents occur due to the driverâ„¢s ignorance of traffic and safety rules. It is a practice for the drivers to drive the vehicle beyond permitted limits. Depending on the terrain, and other conditio ....etc

[:=Read Full Message Here=:]

Difference between CISC and RISC:
CISC stands for Complex Instruction Set Computer. Most PC's use CPU based on this architecture. For instance Intel and AMD CPU's are based on CISC architectures. Typically CISC chips have a large amount of different and complex instructions. In common CISC chips are relatively slow (compared to RISC chips) per instruction, but use little (less than RISC) instructions. MCS-51 family microcontrollers based on CISC architecture.
RICS stands for Reduced Instruction Set Computer ....etc

[:=Read Full Message Here=:]

Speed Control of 3-Phase Induction Motor Using PIC18 Microcontrollers
INTRODUCTION
Induction motors are the most widely used motors forappliances, industrial control, and automation; hence,they are often called the workhorse of the motion industry.They are robust, reliable, and durable. When poweris supplied to an induction motor at the recommendedspecifications, it runs at its rated speed. However,many applications need variable speed operations. Forexample, a washing machine may use different speedsfor each wash cycle. Histor ....etc

[:=Read Full Message Here=:]

please give me more information on microcontroller based automatic dish antenna allinment.
my email id is [email protected] ....etc

[:=Read Full Message Here=:]

Microcontrollers MCS 51 Family
Introduction
Microcontroller and microprocessor
Von Neumann (Princeton) and Harvard architecture
Advantages of use of Microcontroller
Various Applications
Microcontroller and Microprocessor
Data and Program memory is on chip
Peripherals are on chip
Data handling, processing capacity is moderate
Data and Program Memory need to be interfaced externally
Peripherals need to be connected externally
Data handling and processing capacity is large
Applications Like
....etc

[:=Read Full Message Here=:]

ABSTRACT
A microcontroller is sometimes described as a computer on a chip because it contains all the features of a full computer including central processor, in-built clock circuitry, ROM, RAM, input and output ports with special features such as serial communication, analogue-to-digital conversion and, more recently, signal processing.
The smallest microcontroller has only eight pins but some having 68 pins are also being marketed. In the last five years, the prices of microcontrollers have dropped by 80% and a ....etc

[:=Read Full Message Here=:]

The two divergent paths of Microcontroller and DSP may cross occasionally with each performing both tasks. Barriers to entry depend on peripherals, filling the data pipe, and quality of development tools. Designers of today's emerging systems that require both real-time control as well as analog signal processing are looking for ways to reduce cost and speed development time in a market that becoming increasingly competitive. Both technical and personal considerations rule. For a microcontroller engineer to consider a DSP or for a DSP engineer ....etc

[:=Read Full Message Here=:]