¢ DWDM revolutionized data transmission technology by increasing the capacity signal of embedded fiber.

¢ This technology responds to the growing need for efficient and capable data transmission by working with different formats, such as SONET/SDH, while increasing bandwidth.

CHARACTERISTICS OF DWDM
EMBEDDED EQUIPMENT AND FIBER PLANT
SYSTEM ROBUSTNESS AND RELIABILITY
SPLICING IN THE OPTICAL AMPLIFIER
MANUAL INTERVENTION
FLUORIDE OR SILICA-BASED AMPLIFIERS
WAVELENGTHS AND BIT RATE

DWDM IN THE METROPOLITAN AREA NETWORK ....etc

[:=Read Full Message Here=:]

Automotive thermoelectric generator
An automotive thermoelectric generator (ATEG) is a device that utilizes the Seebeck effect in order to recover lost heat from an internal combustion engine powered vehicle, and generate electricity with it. A typical ATEG consists of four main elements: A hot-side heat exchanger, a cold-side heat exchanger, thermoelectric materials, and compression assembly system. ATEGs can be classified according to their hot-side heat exchanger to exhaust-based ATEGs and coolant-based ATEGs. The ....etc

[:=Read Full Message Here=:]

High Speed Downlink Packet Access (HSDPA) – A Means of Increasing Downlink Capacity in WCDMA Cellular Networks
Abstract:
The increasing demand for capacity in order to provide high data rate multimedia services in wireless environments necessitates enhanced radio transmission techniques and network protocol functionality. Such techniques have to be added to already existing mobile cellular networks, e.g. as provided by EDGE. For 3rd generation UMTS networks based on WCDMA, the High Speed Downlink Packet Access (HSDPA) is bein ....etc

[:=Read Full Message Here=:]

I NEED THE ABOVE MENTIONED TOPIC. IAM DOING THE PROJECT BASED ON IT BUT I DIDNT FIND ANY DOCUMENT RELATED TO IT. PLEASE SEND THE DOCUMENT AND SLIDES OF THE PROJECT IF ANYONE IS HAVING PLZ PLZ ....etc

[:=Read Full Message Here=:]

INCREASING PENETRATION OF DISTRIBUTED
GENERATION IN EXISTING DISTRIBUTION
NETWORKS USING COORDINATED VOLTAGE

ABSTRACT
Connections of distributed generation (DG) to weak distribution networks often
experience voltage rise problems. The voltage rise caused by DG can be reduced
with passive methods such as increasing the conductor size but this can be quite
expensive. Active management of distribution networks can allow connection of
more DG into existing distribution networks and, consequently, reduce the connec-
tion ....etc

[:=Read Full Message Here=:]

please suggest me idea for increase the two wheeler mileage.... ....etc

[:=Read Full Message Here=:]

EFFICIENCY INCREASING SYSTEM BY USING PREHEATING METHOD


EFFICIENCY INCREASING SYSTEM BY USING PREHEATING METHOD


METHODOLOGY

The concept of increasing the fuel efficiency of a petrol engine in this project, is to pre-heat the intake air which is flowing through the carburetor. The humidity in the atmospheric air affects the petrol vapourisation in the carburettor. Therefore, by pre-heating the inlet air to the carburettor for a considerable amount, the vapourisation can be ease and ....etc

[:=Read Full Message Here=:]

sir
I am final year Mechanical Engineering student.We need lot of information about our project.we are four members in a project group. Our project topic is AIR PREHEATING SYSTEM IN TWO WHEELERS.
1. At first we need specification of this project?
2. What type of heat exchanger should be used and its cost?
3. We are planned to do it in a 4-Stroke Petrol engine, is it possible?
4. Calculations of this project?
we like to do a real time project , then we selected this project. we like to know complete information about this project.
F ....etc

[:=Read Full Message Here=:]

Hi,

It would be great if i could review any project done on the study of increasing a PV module output using mirriors or any design for a concentrators for a trough system . thanks

Regards

A9913882 ....etc

[:=Read Full Message Here=:]

submitted by :-
Suhail ahmad mansoori


INTRODUCTION
A boiler is an enclosed vessel that provides a means for combustion heat to be transferred into water until it becomes heated water or steam. The hot water or steam under pressure is then usable for transferring the heat to a process. Water is a useful and cheap medium for transferring heat to a process. When water is boiled into steam its volume increases about 1,600 times, producing a force that is almost as explosive as gunpowder. This causes the boiler to ....etc

[:=Read Full Message Here=:]