HOW 2 DO THIS PROJECT? ....etc

[:=Read Full Message Here=:]

give me the detail for this project ....etc

[:=Read Full Message Here=:]

Heart Rate Monitor
Abstract
The aim of this project is to implement an ECG and Digital Heart Rate counter. amplifying

the desired weak signal from the heart and isolating this from the noise signal from the

muscles were the main challenges. A display of the heart rate will also be implemented.The

time between signal peaks will be calculated and then the frequency of the peaks will be

obtained. Attempt is made to make the device portable. low cost amplifier and filter

components were used and it also includes ....etc

[:=Read Full Message Here=:]

Extraction Of Heart Rate Variability

Introduction

Heart Rate Variability (HRV)


HRV is the physiological phenomenon where the time interval between heart beats varies.

Dependant on the extrinsic regulation of the heart rate.

Useful for understanding the status of Autonomic Nervous System (ANS).
....etc

[:=Read Full Message Here=:]

The Highly variable round-trip times (RTTs) in wireless networks causes spurious timeouts which can be a reason for the unnecessary retransmission and the thus unnecessarily degrading throughput for the Transmission Control Protocol (TCP).The methods to improve TCP throughput in wireless networks is discussed in this article. One of the method involves the use of a retransmission timeout (RTO) threshold which is slightly higher than the standard. The other method described involves the use of selective repeat (SR) and go-back-N (GBN) as retran ....etc

[:=Read Full Message Here=:]

hello
i am a final year student of Electronics Engg.
I require a project for final year project submission,
so, i request you to provide me the details of the project i have mentioned below on my email address [email protected]
thanking you.

WIRELESS RF PULSE RATE/HEART BEAT COUNTER GRAPH PLOTTER: The simple
event counter with dual display and a minute timer can count the RF pulses of HEART coming from
distance and plot the graph on paper to read. The pulse rate of heart will be taken from the Infrared
IR finger sens ....etc

[:=Read Full Message Here=:]

ABSTRACT
HEART RATE DISPLAY USING 8051 MICROCONTROLLER
AIM:
The aim of this project is to implement an ECG and Digital Heart Rate counter. The main challenges include amplifying the desired weak signal in the presence of noise from other muscles and electrical sources. A display of the heart rate will be obtained by measuring the time between signal peaks and then calculating the frequency of the peaks in units of beats per minute.
PURPOSE:
The heart is one of the most vital organs within the human body. ....etc

[:=Read Full Message Here=:]

Microcontroller-Based Heart-Rate Meter

Prof. K. Padmanabhan

introduction

Heart rate can be measured either by the ECG waveform or by the blood flow into the finger (pulse method). The pulse method is simple and convenient. When blood flows during the systolic stroke of the heart into the body parts, the finger gets its blood via the radial artery on the arm. The blood flow into the finger can be sensed photoelectrically. To count the heart beats, here we use a small light source on one side ....etc

[:=Read Full Message Here=:]

ABSTRACT
This paper presents a new measure of heart rate variability (HRV) that can be estimated using Doppler ultrasound techniques and is robust to variations in the angle of incidence of the ultrasound beam and the measurement noise. This measure employs the multiple signal characterization (MUSIC) algorithm which is a high-resolution method for estimating the frequencies of sinusoidal signals embedded in white noise from short-duration measurements. We show that the product of the square root of the estimated signal-to-noise ratio ....etc

[:=Read Full Message Here=:]

ABSTRACT
This project presents the optimal design of a health monitoring device worn during exercise--the
body heart rate monitor. The product provides the time and duration of exercise session, heart
rate of user, and calories burned during the session. The primary target market includes fitness
enthusiasts, professional and armature runners and cyclists, and heart patients.
The objective from an engineering viewpoint was to minimize overall size and weight, resulting
in an optimal size being 21 cm3 and weight being 143 g. The ....etc

[:=Read Full Message Here=:]