how to prepare a cbse project report on full wave rectifier for class 12?
what should all be in the report or tellme about contents. ....etc

[:=Read Full Message Here=:]

please give me a project on rectifiers as soon as possible....
....etc

[:=Read Full Message Here=:]

INTRODUCTION
Efficient control of D.C motor speed is very economical to any industries for that reason we are using full wave rectifier in which we are using triacs as switches because of bi-directional nature of triacs we are preferred instead of using thyrister as a switches. To obtain a four quadrant operation we need 8 switches if we use thyristers (this circuit called dual converter) and if we use triacs we need 4 switches only.
....etc

[:=Read Full Message Here=:]

urgent need OF FULL WAVE RECTIFIER, ITS TOO IMP. COZ SCHOOL NEED IT I WANT TO HAVE IT FOR MARKS
DFGRHEYHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHH ....etc

[:=Read Full Message Here=:]

Abstract
This paper proposes a feed-forward control in a halfbridgeresonant dc page link inverter. The configuration of feed-forwardcontrol is based on synchronous sigma-delta modulation and the halfbridgeresonant dc page link inverter consists of two inductors, onecapacitor and two power switches. The simulation results show theproposed technique can reject non-ideal dc bus improving the totalharmonic distortion.
Keywords—Feed-forward control, Resonant dc page link inverter,Synchronous sigma-delta modulation.
I. INTRODUCTION[/b ....etc

[:=Read Full Message Here=:]

Single-phase half-bridge inverter


Operational Details

Consists of 2 choppers, 3-wire DC source
Transistors switched on and off alternately
Need to isolate the gate signal for Q1 (upper device)
Each provides opposite polarity of Vs/2 across the load

DC Supply Current
If the inverter is lossless, average power absorbed by the load equals the average power supplied by the dc source.
For an inductive load, the current is approximately sinusoidal and the fundamental component of the o ....etc

[:=Read Full Message Here=:]

Presented By
Haseena Hassan


The Half Adder & Full Adder
The Half Adder
Adds two binary digits
Produces a sum bit(S) and a carry bit(C)
Carry C is the AND of A and B
ie,C=AB
Sum is the X-OR of A and B
ie,S=AB+AB
The Full Adder
Adds two bits and a carry input
Outputs a sum bit and a carry
Adds the bit A&B and carry frm previous column(carry in)
Logic Diagram of full adder
....etc

[:=Read Full Message Here=:]

its important & urgent because its means a lot for me . it stands for a large portion of my marks so please help me .........
... ....etc

[:=Read Full Message Here=:]

Name– study of half adder logic circuit.
Aim – to study the working of half adder for two binary digits addition.
Apparatus – IC 7408, IC 7486, circuit board, LEDs, power supply +5V DC, connecting wires, soldering iron, cutter etc.
Circuit diagram


Procedure –
1) Solder the circuit on the given board.
2) Connect respective pins of each gate to the corresponding pins of other gate.
3) Connect the outputs ‘sum’ and ‘carry’ to two LEDs.
4) Apply diff ....etc

[:=Read Full Message Here=:]

Please send me the simulink model of bidirectional dc-dc converter non-isolated ....etc

[:=Read Full Message Here=:]