Structural and thermal analysis of gas turbine casing

ABSTRACT
Gas Turbine is a rotary engine, which converts the energy of hot gases into mechanical energy. The hot flue gasses at high pressure and high temperature expand in the turbine section to produce mechanical work. Turbine casing (shell) controls the axial and radial positions of the shrouds and nozzles.
It determines Turbine clearances and relative positions of the nozzles to the Turbine buckets. This positioning is critical to Gas Turbine perf ....etc

[:=Read Full Message Here=:]

ABSTRACT
A new generation of small scale (less than 20 MWe) biomass fueled, power plants are
being developed based on a gas turbine (Brayton cycle) prime mover. These power plants
are expected to increase the efficiency and lower the cost of generating power from fuels
such as wood. The new power plants are also expected to economically utilize annual
plant growth materials (such as rice hulls, cotton gin trash, nut shells, and various straws,
grasses, and animal manures) that are not normally considered as fuel for power plants.
This p ....etc

[:=Read Full Message Here=:]

High Efficiency Miller Cycle Gas Engine
1. INTRODUCTION
The output of gas engines for cogeneration mainly ranges from 100 to 1 000 kW. The present gas engines are broadly classified in two types: lean-burn system (1) and stoichiometric air-fuel ratio combustion system, with the lower output engines using the stoichiometric Air-fuel ratio combustion system while the medium and large size engines adopting the lean-burn system. The lean-burn system generally features in high generating efficiency and low NOx emission in ad ....etc

[:=Read Full Message Here=:]

Miller cycle gas engine PPT presentation ....etc

[:=Read Full Message Here=:]

i am 8th sem BE student ,i want to ppt of High Efficiency Miller Cycle Gas Engine,what is the small explanation of High Efficiency Miller Cycle Gas Engine =medium] ....etc

[:=Read Full Message Here=:]

Preface:
Power generation is an important issue today, especially on the West Coast. Demand is outweighing supply because of lack of incentives for the utilities industry to build additional power plants over the past 10-20 years. Electrical innovations (such as the personal computer) were not accounted for in earlier predictions of power utilization and, now, the country is in dire need of streamlining the current power plants while pushing through as many applications as possible for new power plants. In response to this situation, ....etc

[:=Read Full Message Here=:]

The gas turbine has been an enormously successful power plant for aircraft and marine propulsion, and electric power generation, due to its lightweight, smooth and reliable operation, low emissions, and varied applications. Nevertheless, it is not very efficient in converting fuel energy to useful work, due to fundamental thermodynamic limitations imposed by turbo machinery technology.

In recent years, there is renewed interest in the potential high efficiency of alternative thermodynamic cycles and unsteady combustion systems for propul ....etc

[:=Read Full Message Here=:]

i am rahul , doing M.Tech from SVNIT surat. i know the basics of EGR of gas turbine engines. i want the full project report ....etc

[:=Read Full Message Here=:]

SYNOPSIS
An alternative configuration for a regenerative gas turbine engine cycle is presented that yields higher cycle efficiencies than either simple or conventional regenerative cycles operating under the same conditions. The essence of the scheme is to preheat compressor discharge air with high temperature combustion gases before the latter are fully expanded across the turbine. The efficiency is improved because air enters the compressor at a higher temperature, and hence heat addition in the co ....etc

[:=Read Full Message Here=:]

....etc

[:=Read Full Message Here=:]