im HUSSAM HAMMADEEN , im a student in Hijjawi faculty for engineering,electrical power engineering ,,
im ask for this project and a simulink part for Doubly Fed Induction Generator Using Back-To-Back PWM Converters and Its Application to Variable Speed Wind-Energy Generation with its mathematical equations and values that make the system stable ..
i do my research for wind speed area less than 6 m/s ,,,
i will thanks .. ....etc

[:=Read Full Message Here=:]

Sir/Madam
Can i get the information regarding the above mentioned project topic. ....etc

[:=Read Full Message Here=:]

Doubly-Fed Induction Generator for Variable Speed Wind Energy Conversion Systems- Modeling & Simulation
Abstract— The aim of this paper is to present the complete modeling and simulation of wind turbine driven doubly-fed induction generator which feeds ac power to the utility grid. For that, two pulse width modulated voltage source converters are connected back to back between the rotor terminals and utility grid via common dc link. The grid side converter controls the power flow between the DC bus and the AC side and allows t ....etc

[:=Read Full Message Here=:]

DOUBLY FED INDUCTION MACHINE

INTRODUCTION
ELECTRICAL MACHINES
Based on the supply, 2 types-AC machine & DC machine
AC machines are of different types
1. Induction machine
2. Synchronous machine etc.

INDUCTION MACHINE
Induction machines are of different types and one of the type in particular are Singly Fed and Doubly Fed.
SINGLY FED INDUCTION MACHINE
1. Only ONE winding active in ENERGY conversion Process
2. Can have speed around Synchronous Speed.

DOUBLY FED INDUCTION MACHINE
T ....etc

[:=Read Full Message Here=:]

Control of variable speed wind turbines equipped with synchronous or doubly fed induction generators supplying islanded power systems
Abstract:
A control method for variable speed wind turbines (VSWTs) supplying islanded parts of electricalnetworks is presented. Active power/frequency and reactive power/voltage droops are applied in order todetermine the active, reactive power production, thus downscaling to the VSWTs the conventional controlconcepts of the power plants. Two types of VSWTs comprising doubly fed induction gene ....etc

[:=Read Full Message Here=:]

Introduction to Pulse Width Modulation (PWM)
In this technique several pulses are produced in each half – cycle but the width of the pulses
is not the same as in case of multiple – pulse width modulation, however the width of each pulse is
varied in accordance with the amplitude of the sine wave reference voltage. The width of the pulse
at the center of the half – cycle is maximum and decreases on either side. The figure 6(a) shows the
generation of the output signal by comparing a sinusoidal reference sign ....etc

[:=Read Full Message Here=:]

hello,

please provide me the abstract and the full article details..
thanks.. ....etc

[:=Read Full Message Here=:]

ENHANCED PERFORMANCE OF A DOUBLY FED
WIND-POWER INDUCTION GENERATOR AT WIND-
RANGE BOUNDARIES
ABSTRACT
The doubly fed induction generator (DFIG) is one of the largest generators used
with MW-class wind turbines. This paper focuses on the weak performance areas
of grid-connected DFIG-based wind turbines. Basically, the DFIG performance at
low wind speeds, close to the cut in speed, and around the full rating operation (in
the vicinity of rated wind speed) is investigated. For low wind speed region, the
c ....etc

[:=Read Full Message Here=:]

Control Dynamics of a Doubly Fed Induction Generator Under Sub- and Super-Synchronous Modes of Operation


M. Aktarujjaman, Student Member,
IEEE, M.E. Haque, Member, IEEE, K. M. Muttaqi, Senior
Member, IEEE, M. Negnevitsky, Member,
IEEE and G. Ledwich, Senior Member, IEEE


Abstract-
Abstract—
Depending on wind speed, a doubly fed induction generator (DFIG) based variable speed wind turbine is capable of operating in sub- or super-synchronous mode of operation using a back to back PWM co ....etc

[:=Read Full Message Here=:]

Modeling and Simulation of Speed of a Doubly Fed Induction Motor with Different Regulators
Many industrial applications require new control techniques in order to obtain fast response and to improve the dynamic performances. One of the techniques users, sliding mode,fuzzy logic and fuzzy sliding mode control which are characterizes by robustness and insensitivity to the parameters variation. In this paper, we present a comparative study of a direct stator flux orientation control of doubly fed induction motor ....etc

[:=Read Full Message Here=:]