non isolated high step up boost converter integrated with sepic converter matlab simulink model ....etc

[:=Read Full Message Here=:]

ppt for nonisolated high stepup boost converter integrated with sepic converter ....etc

[:=Read Full Message Here=:]

DESIGN AND DEVELOPMENT OF HIGH-FREQUENCY THERMOACOUSTIC ENGINES FOR THERMAL MANAGEMENT IN MICROELECTRONICS
SEMINAR REPORT
Submitted by
VIBIN KOSHY THOMAS
S7-ME
Department Of Mechanical Engineering
College of Engineering, Thiruvananthapuram – 16
OCTOBER 2010





ABSTRACT

Thermoacoustic heat engines provide a practical solution to the problem of heat management in microcircuits where they can be used to pump heat or produce spot cooling of specific circuit elements. There are ....etc

[:=Read Full Message Here=:]

HIGH-DENSITY EMI FILTER DESIGN FOR DC-FEDMOTOR DRIVES



INTRODUCTION

Electromagnetic interference (EMI) is one of the major design challenges in motor drive systems, especially in applications where stringent standards need to be followed. EMI noise is usually defined as common-mode (CM) and differential-mode (DM) noise. CM noise is defined as the noise flows between the power circuit and the ground, while DM noise is defined as the current following the sam ....etc

[:=Read Full Message Here=:]

Practical Implementation Of A High-frequency Current Sense Technique For VRM
presented by :
Sarath T S
AE&I
College Of Engineering, Trivandrum3


Hi Friends, If you like this presentation, say hi to the author who has shared it with you at:+919895691446, [email protected]
Overview

Introduction
Traditional methods
DCR method
Theoretical basis analysis
Effect of temperature
Current sense methods comparison
Problems and solutions
Experimental results ....etc

[:=Read Full Message Here=:]

High frequency inverter design for large-signal characterization of domestic
induction heating load
Abstract –
Current research topics in the field of domesticinduction heating entail analytical study of inductor-potcoupling behavior which must be verified with experimentalresults. Small-signal measurements are easily achieved up to 1MHz with commercial LCR meters. On the other hand, largesignalexperimentation requires a custom made measurementtest bench. Whatever the approach selected to design thissystem, the ....etc

[:=Read Full Message Here=:]

i want report on the topic high step up dc dc converter for a microgrid plz help ....etc

[:=Read Full Message Here=:]

i need fulldetails about this paper ....etc

[:=Read Full Message Here=:]

High Frequency Low Cost DC-AC Inverter Design with Fuel Cell
Source for Home Applications
ABSTRACT:
This paper presents a new design of highfrequency Dc/Ac inverter for home applications using fuel cellsor photovoltaic array sources. A battery bank parallel to the DClink is provided to take care of the slow dynamic response of thesource. The design is based on a push-pull dc/dc converterfollowed by a full-bridge PWM inverter topology. The nominalpower rating is 10kW. Actual design parameters, procedure andexperimental results of a 1 ....etc

[:=Read Full Message Here=:]

what are the applications of resonant sepic converter ....etc

[:=Read Full Message Here=:]