i need code for decode and forward relaying in the gaussian reley channel...esp to maximize its throughput....
and also need code for clustering algorithm which uses energy harvestors...
....etc

[:=Read Full Message Here=:]

ABSTRACT

Leakage power consumption is large fraction of the total power consumption in contemporary VLSI designs. Since memories occupy a large portion of the total area of many high-performance ICs, it is crucial to reduce the leakage energy of memories. This problem is particularly aggravated for memories implemented in the 45nm technology node, since these processes exhibit significantly higher leakage power. For these memories, leakage is a significant problem not only from a power point of view, but also from performance degradation st ....etc

[:=Read Full Message Here=:]

please help in matlab programming of load flow analsis of radial distribution network ....etc

[:=Read Full Message Here=:]

Decode and forward matlab code for single relay between the sender and receiver ....etc

[:=Read Full Message Here=:]

This article is presented by:
HONG Jingxin
Communication Engineering Department of Xiamen University

A New Forward-Secure Digital Signature Scheme
ABSTRACT
In this paper, the widely used ECC digital signature scheme – ECDSA is advanced, and a new forward-secure digital signature scheme is proposed in order to reform the limitations of ECDSA. In the new scheme, although the digital signature’s private key is under the control of a one-wa ....etc

[:=Read Full Message Here=:]

Introduction:
The buck derived forward converter is one of thenwst popular switchnwde topologies, second only tothe infanwusflyback converter. High input to outputstep down or up in voltage is easily achieved byusing the appropriate transformer turns ratio.Galvanic isolation is frequently added between thesupply and load ..grounds for increased safety andprotection or to supply power to an isolated load.F or these and other reasons, the forward converterhas become a cost effective solution to many powermanagement needs. With its conti ....etc

[:=Read Full Message Here=:]

Abstract—RFID has been gaining popularity due to its variety of applications, such as inventory control and localization. One important issue in RFID system is tag identification. In RFID systems, the tag randomly selects a slot to send a Random Number (RN) packet to contend for identification. Collision happens when multiple tags select the same slot, which makes the RN packet undecodable and thus reduces the channel utilization. In this paper, we redesign the RN pattern to make the collided RNs decodable. By leveraging the collision slots, ....etc

[:=Read Full Message Here=:]

Introduction

The packet transport service provided by representative packet-switched networks, including IP networks, is not reliable and the quality-of-service cannot be guaranteed. Packets may be lost due to buffer overflow in switching nodes, be discarded due to excessive bit errors and failure to pass the cyclic redundancy check at the page link layer, or be discarded by network control mechanisms as a response to congestion somewhere in the network. Forward Error Correction coding has often been p ....etc

[:=Read Full Message Here=:]

i want the code that can identify the messages. also steps to configure uart for this purpose ....etc

[:=Read Full Message Here=:]

hi, I need backward forward sweep load flow to perform my project
please help me with this ....etc

[:=Read Full Message Here=:]