Embedded system design is a topic of interest to multidisciplinary fields including electrical engineering and computer science. In order to correctly focus on the correct aspects of embedded system design, be it hardware for electrical engineering students, or software for computer science students, seamless connectivity between the hardware and software aspects needs to be provided. One approach to provide students from both fields with practical experience is to develop a transparent bridge between the hardware and software layers of the e ....etc

[:=Read Full Message Here=:]

WIRELESS BATTERY CHARGING SYSTEM USING RADIO FREQUENCY ENERGY HARVESTING




INTRODUCTION AND MOTIVATION

Cellular telephone technology became commercially available in the 1980’s. Since then, it has been like a snowball rolling downhill, ever increasing in the number of users and the speed at which the technology advances. When the cellular phone was first implemented, it was enormous in size by today’s standards. This reason is two-fold; the battery had ....etc

[:=Read Full Message Here=:]

Remote device control using Radio Frequency


The project compares the communication of control signals using radio frequency
and Infra Red Rays. The STR is ideal for short-range remote control applications where
cost is a primary concern. The receiver module requires no external RF components
except for the antenna. It generates virtually no emissions, making FCC and ETSI
approvals easy. The super-regenerative design exhibits exceptional sensitivity at a very
low cost. A SAW filte ....etc

[:=Read Full Message Here=:]

Definition

RF light sources follow the same principles of converting electrical power into visible radiation as conventional gas discharge lamps. The fundamental difference between RF lamps and conventional lamps is that RF lamps operate without electrodes .the presence of electrodes in conventional florescent and High Intensity Discharge lamps has put many restrictions on lamp design and performance and is a major factor limiting lamp life.

Recent progress in semiconductor power switching electronics, which is revolutionizing many facto ....etc

[:=Read Full Message Here=:]

Characterization of radio frequency plasma using Langmuir probe
and optical emission spectroscopy
M. Nisha, K. J. Saji, R. S. Ajimsha, N. V. Joshy, and M. K. Jayaraj
a
Optoelectronics Devices Laboratory, Department of Physics, Cochin University of Science
and Technology, Kochi-682 022, Kerala, India
Received 21 February 2005; accepted 4 January 2006; published online 15 February 2006
The radio frequency plasma generated during the sputtering of Indium Tin Oxide target using Argon
was analyzed by Langmuir probe and optical-emission spec ....etc

[:=Read Full Message Here=:]

I want seminar report on controlling ip spoofing through inter domain packet filters URGENTLY........ ....etc

[:=Read Full Message Here=:]

After years of research and development, radio frequency light sources are just now becoming a mainstream lighting option. RF light sources follow the same principles of converting electrical power into visible radiation as conventional gas discharge lamps. The fundamental difference between RF lamps is that RF lamps operate without electrodes .There are three practical ways to energize RF light sources, though there are more ways to create RF plasmas. These three ways correspond to different types of interaction of electroma ....etc

[:=Read Full Message Here=:]

A Technique for Orthogonal Frequency Division Multiplexing
Frequency Offset Correction

Abstract:
The Orthogonal Frequency Division Multiplexing (OFDM) is a Multi Carrier Modulation technique employing Frequency Division Multiplexing of orthogonal subcarriers. It is also sometimes called as discrete multitone modulation (DMT). It is better than CDMA in high bit rate and Broadband Communications .It is a multi carrier technique, which is very sensitive to Frequency Offset between transmitter and receiver. Th ....etc

[:=Read Full Message Here=:]

EMBEDDED BASED RADIO FREQUENCY SPEED CONTROL OF DC MOTOR



The project ‘’EMBEDDED BASED RADIO FREQUENCY SPEED CONTROL OF DC
MOTOR’’ is used to varying Speed of The dc motor. It is need a DC to DC converter
is a Circuit Which converts a source of direct current (DC) from one voltage Level to
Another.
Linear regulators output can only in low in low voltage From the Input.
They are very inefficient if the voltage drop is large and the Current high as they
dissipate as heat, a power equal To the product of the output current and ....etc

[:=Read Full Message Here=:]

presented by:
Daniel W. Harrist


Abstract

It seems these days that everyone has a cellular phone. Whether yours is for business purposes or personal use, you need an efficient way of charging the battery in the phone. But, like most people, you probably don’t like being tethered to the wall. Imagine a system where your cellular phone battery is always charged. No more worrying about forgetting to charge the battery. Sound Impossible?
It is the focus of this thesis to discuss the first step toward ....etc

[:=Read Full Message Here=:]